Model #KSRB25FKBL04 KITCHENAID Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Parts Not Illustrated
    3 Results
Find part by diagram >

Question and Answers

Q:

What can be the problem with my icemaker?

A:

The icemaker in this model can stop working for a few reasons. Some are listed below:

  • The icemaker itself can fail
  • The water valve may not open
  • The optic boards can fail
  • The fill tube can freeze up
  • Freezer temperature not cold enough
The blinking led light can be flashing a code that will indicate the problem. If it flashes 2 times pauses and continues this while the door is open, it’s normal. Now press in the flapper door on the left side and tape it closed (it must stay closed to make checks). With the flapper door pressed in, the LED should be on steady. I'm sending a chart for the LED codes. If the Led is working normal, it indicates the optic boards are ok and the icemaker will need to be checked. There are some test terminals on the icemaker module that may help determine the problem (see picture). To access the module, the icemaker will have to be pulled out. I'm sending pictures and instructions to remove this icemaker. With the icemaker out, now pull the front cover off to access the module and the test terminals. Use a well insulated jumper and place it between the L - V terminals. Be careful this is a hot live check. With the jumper in place, water should now flow to the icemaker (be prepared to catch water from the fill tube). If water does flow, the icemaker will need to be replaced. If no water flows but you can hear a humming noise, the water valve will need to be replaced. If nothing at all happens, some voltage checks will need to be made. If you do not feel confident repairing this problem or doing any voltage checks yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Safety Notice: Be sure to disconnect the appliance before performing any troubleshooting procedures. If you are not comfortable with doing any voltage checks or repairs that might be recommended, please contact a local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Scott D -
Sears Technician
March 03, 2010

Top Parts