Model #KSRB25FHSS03 KITCHENAID Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Freezer Liner
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Air Flow
    3 Results
  • Control
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Question and Answers

Q:

refrigerator door not closing

A:

I can understand your concern over the door to your refrigerator not staying shut. While you are waiting for your expert answer, I did some research on the unit. At this time, I was unable to locate information that would be helpful in regards to your question. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner.

Read More
Julio -
December 29, 2012
A:

Hi,

Thank you for asking this question and allow me to answer it this way.

Yes the door closer cams are replaceable and the easiest way is the first remove the door. Tape the refrigerator door in place and remove the upper hinge assembly and then carefully remove the door and place it on a padded table. remove the old cam off the door and replace with the new one. Remove and replace the cam on the lower hinge and replace the door, again tape the door to the cabinet and tighten the upper hinge assembly.

I hope this answer is useful and that it helps you correct the problem with your appliance.
Thank you for using ManageMyLife.

Read More
Bill__W -
Sears Technician
December 31, 2012
See more answers
Q:

Why does my KitchenAid fridge #KSRB25FHSS03 have horizontal cracks all down the outside edge of the door?

A:

If you mean the cracks are down the edge of the inner door panel, the door may need to be replaced. Sometimes the inner panel may crack and since this is a one piece door, the only fix would be to replace the complete door. If the door still seems to be working ok and is sealing good, then it's not necessary to replace it. It won't make any difference in how the unit is working.

No, an in-line water filter will not extend the life of the filter inside the unit. The control board still counts the amount of water being used and will determine the life of the filter.

Read More
Scott D -
Sears Technician
August 13, 2009

Top Parts