Model #KSRB22FHSS04 KITCHENAID Side-by-Side Refrigerator

  • Cabinet
    3 Results
  • Refrigerator Liner
    3 Results
  • Refrigerator Shelf
    3 Results
  • Motor And Ice Container
    3 Results
  • Refrigerator Door
    3 Results
  • Freezer Door
    3 Results
  • Dispenser Front
    3 Results
  • Unit
    3 Results
  • Freezer Liner
    3 Results
  • Air Flow
    3 Results
  • Ice Maker
    3 Results
  • Control
    3 Results
Find part by diagram >

Question and Answers

Q:

Why is my ice maker not working?

A:

The first thing you need to check is if the fill tube is frozen. If the fill tube is frozen up, the water line will pop off when the ice maker cycles & calls for water. This type of failure will require the replacement of the water inlet valve. Be sure to defrost the fill tube before replacing the water inlet valve. You can use a hair dryer to help with the defrosting.

Read More
biker dave -
Sears Technician
August 22, 2008
Q:

Why is the icemaker not getting water?

A:

The most common cause for the icemaker to stop filling is the icemaker fill tube ices up. This is caused from the water valve not cutting off completely. A small seep comes from the icemaker water valve and freezes inside the fill tube stopping it up.

Look inside the freezer above and behind the icemaker. If the fill tube is frozen up you can defrost it with a hair dryer.

If the fill tube is not frozen up the surest way to test the water valve is to pull the refrigerator away from the wall and unplug it. Remove the lower cover across the rear of the cabinet.

There are two connectors for the solenoid coils on the water valve. If the valve has 3 solenoids disregard the one that is not close to the two at the rear of the valve. Each connector has 2 wires in it. Swap the 2 connectors on the solenoids. This will cause the dispenser to send power to the icemaker solenoid when you call for water at the dispenser. Plug the refrigerator in and press the paddle for water. If water doesn't run into the icemaker the solenoid is bad. If water does run into the icemaker, replace the icemaker.

Read More
biker dave -
Sears Technician
August 21, 2008
Q:

Why is my ice maker not working?

A:

The first thing you need to check is if the fill tube is frozen. If the fill tube is frozen up, the water line will pop off when the ice maker cycles & calls for water. This type of failure will require the replacement of the water inlet valve. Be sure to defrost the fill tube before replacing the water inlet valve. You can use a hair dryer to help with the defrosting.

Read More
biker dave -
Sears Technician
August 21, 2008

Top Parts