Model #KSRA25ILSS03 KITCHENAID Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Parts Not Illustrated
    3 Results
Find part by diagram >

Question and Answers

Q:

Kitchenaid Ice Maker not working

A:

When summer is here all we can think about is drinking nice cold drinks. While you are waiting on an expert to answer your question, I found a great link in the Manage My Life website on your problem. I have attached the link below. Hope this helps!

Read More
Dezeray -
January 29, 2013
A:

To clarify, my comment " I am pretty handy, but want to be careful in removing and replacing the bin." I meant removing and replacing the ice maker...

Read More
Derek -
January 29, 2013
A:

I know that it can be very frustrating to have issues with your ice maker. Be sure your freezer temperature is below 15 degrees. The thermostat inside the icemaker closes at 12-15 degrees and starts the harvest cycle. I am sending you instructions for manually initiating the harvest cycle. Disconnect the power to the refrigerator while you are inserting the jumper described in the instructions. Be sure the jumper is made from insulated wire with the ends stripped back to avoid electrical shorts or shock. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
January 29, 2013
A:

AnneJ, thanks for the suggestion. I have not been able to act on it, as I still have not received infomation on how to remove the ice maker or access the motor test points, since they are behind the motor enclosure and it is not obvious how to remove the enclosure. There are several screws on the bottom of the ice tray, but I am not sure if I need to remove them all or certain ones, or if there are other clips/screws that need to be removed. Also, I am assuming when you state I need to apply the jumper to the test points, this has to be done while the ice tray is in the freezer. Is the procedure to take the ice tray out and then plug th eharness back in and set the ice maker down on one of the racks to keep it in the cold freezer?

Read More
Derek -
January 30, 2013
A:

On this model you do not need to remove the ice maker from the freezer wall, unless this will make it easier for you to test. The image below will show you how to do this. As for the cover, you just need to pull it off to access the test points. Please let me know if you need anything else. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
January 30, 2013
See more answers

Top Parts