Model #KGST307HBT9 KITCHENAID Slide-In Range, Gas

  • Cooktop/literature
    3 Results
  • Cooktop Burner
    3 Results
  • Control Panel
    3 Results
  • Door And Drawer
    3 Results
  • Oven Chassis
    3 Results
  • Broiler And Oven Burner
    3 Results
  • Oven
    3 Results
  • Rear Chassis
    3 Results
Find part by diagram >

Question and Answers

Q:

oven not heating properly KGST307HBT9 Kitchenaid Gas slide in range

A:

Thanks for the inquiry and for being a valued member.

I am sorry to hear of the issue you’re having with the oven not heating properly. I know how frustrating that is. There are several components that can cause the oven to stop heating properly.

If the bake igniter is glowing red and it takes long time for the gas valve to open, the bake igniter is weak and will need to be replaced. When an igniter becomes weak, it cannot pull enough current/amperage to cause the gas valve to open or it can take it a long time to open.

Another possibility is with the oven temperature probe sensor. If the sensor is defective, it won’t properly sense the oven temperature and tell the control when to kick on the heat. The sensor can be tested with a meter for resistance to see if it’s at fault. At room temperature, the sensor test at approximately 1100 ohms. If it checks out, the issue will more than likely be with the igniter or the electronic control.

If you would feel more confident have a Sears Home Service technician help assist with the diagnosis/repair, you can call 1-800-469-4663, or click here to be directed to the page to set up service.

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business.  

Read More
Jeff Wallace Sr -
Sears Technician
December 15, 2014
Q:

Where do i find/locate the wires to replace oven flat ignitor?

A:

It can be challenging to replace certain parts. While you wait for the expert, you might find some help in the diagrams for this model at Sears Parts Direct. I attached the link below. I hope this helps.

Read More
Barbara -
December 15, 2012
A:

Thank you for your question and I understand your concern.

In order to access and replace the bake igniter you will need to remove the floor of the oven and remove the storage drawer. Remove the 4 screws from the oven floor and remove the oven floor. Remove the 4 screws holding the flame spreader down. Remove the screws securing the bake igniter to the bracket. The wires can be access at the back of the range after removing the storage drawer. If your not able to access and disconnect the wires, you will need to slide the range out and remove the lower panel.

NOTE: Disconnect the range from the power supply before servicing.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
December 17, 2012
See more answers