Model #KAWS677EQ0 KITCHENAID Residential Washers

  • Top And Cabinet
    3 Results
  • Rear Panel
    3 Results
  • Control Panel
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Machine Base
    3 Results
  • Miscellaneous
    3 Results
  • Gearcase
    3 Results
  • Brake And Drive Tube
    3 Results
  • Wiring Harness
    3 Results
Find part by diagram >

Question and Answers

Q:

replacing washer belt

A:

It is always great on trying your own repairs on your washer or any appliances yet it can be tough. I have done some research on the Manage My Life website and have located several links that you may find helpful towards your issue. While you are waiting for a detailed reply from an expert I have provided the links below. Hope this helps!

Read More
Priscilla V -
May 06, 2012
A:

Thank you for your question and I understand your concern.

Your model washer does not have drive belt. It uses a motor coupler to connect the gear case to the motor.

I added a YouTube video showing the procedure of removing and replacing the motor coupler .

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
May 07, 2012
A:

hey thanx joey s. I 'm a little confused on the belt issue not sure but i rechecked the part #s when i took the motor off the mounts their was a small belt that was broken inside the machine thats what made me think that it was belt driven,not sure where the belt came from.looked up and dwn this entire machine,i dont even see a pully for the belt.but never the less thanks for helping me out .im gonna go buy a motor coupler tomorrow ask a few more questions then i will install the coupler..thanks again for your time and help joe...

Read More
bill -
May 07, 2012
A:

Bill: If the "belt" you found is about 6inches in diameter and is made of high density foam, this would wrap around the brake drum directly under the tub. It is not needed and is used to help isolate the brake noise. If the "belt" is the diameter of the tub, it is likely the seal that fits under the tub cover that is on top of the tub.

Read More
Joey S -
Sears Technician
May 08, 2012
A:

hey thanks again joey,the information you gave me was very knowledgable..everything worked out great..couple days ..but the experience was worth it...

Read More
bill -
May 08, 2012
See more answers

Top Parts