Model #JTP27WA1WW GE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Upper Body
    3 Results
  • Center Spacer
    3 Results
  • Lower Body
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I need a wiring diagram that illustrates the new wire routing from my GE oven model JTP27W to the control panel replacement ERC3DD.

A:

A wiring diagram is important to have when performing a control board replacement. An expert will be able to provide you with the information you need. It usually takes 24-48 to receive a response. Have a good day.

Read More
Jackie S -
March 22, 2012
A:

Correction: Wire routing diagram is needed for GE Oven model JTP27W to GE Oven Control part ERC3B. Part number associated with this oven is WB27T10272. Instructions were not found in box.

Read More
Tom -
March 22, 2012
A:

I am showing that the part number for the ERC3B control board on GE oven model JTP27WA1WW is WB27T10065. I do not see a valid substitute for that control board. There are some websites that show control board WB27T10272 as being a valid substitute control board for WB27T10065 but I do not show that information. I checked with GE and they do not show that control board as a valid substitute. They could not provide wiring information for that WB27T10272 control board. If it is a valid substitution, then you may be able to use the original wiring diagram and control board diagram shown in the first image. The second image shows a photograph of the WB27T10272. If you are able to properly wire that control board up with the certainty that it is connected properly, then you may be able to use it. If not, then I recommend that you send that original control board WB27T10065 to Core Centric Solutions for repair. That repair usually costs around $150. Here is a link for that circuit board repair company that has contact information: Core Centric Solutions.com . If you need more help, reply with additional details and we will try to assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
March 23, 2012
A:

The photo you provided illustrates that the spade connector for ground is no longer there in the lower right hand corner. This reflects my situation: the replacement control board no longer has a ground connection. GE did not include any instructions in their shiping box.

Read More
Tom -
March 23, 2012
A:

If every other wire on that control board has a proper connection except that there is not connection for a ground wire, then that replacement control board probably no longer uses an earth ground connection. There are several similar substitution control boards that no longer need that ground wire. If the control board is connected properly and works okay without that ground wire, then you should be okay.

Read More
Lyle W -
Sears Technician
March 23, 2012
See more answers

Top Parts