Model #JGS905SEK2SS GE Slide-In Range, Gas

  • Gas & Burner Parts
    3 Results
  • Control Panel
    3 Results
  • Cooktop
    3 Results
  • Body Parts
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
  • Cooling Fan
    3 Results
Find part by diagram >

Question and Answers

Q:

GE Slide In Range #JGS905SEK2SS

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Yadira B -
August 07, 2013
A:

Thanks for contacting manage my life about your range/oven model JGS905SEK2SS, I will be glad to assist you with this question. Sorry you have encountered a problem with the igniter connector. Unfortunately after researching I find that the manufacture does not provide a replacement wiring harness for the igniter or even the complete range. The igniter does come with the connector end (but that only give you half of the entire connection. )The solution for your issue would be to hard wire the igniter with ceramic wire nuts (available at most hardware stores.) This would insure a secure connection and be trouble free. I hope this helps, if you need more assistance reply with added details and I will be happy to respond.  If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services. Ron H.

Read More
Ron H -
Sears Technician
August 08, 2013
A:

after replacing the igniter my stove still don't light what else controls the igniter

Read More
STEVE -
December 22, 2014
See more answers
Q:

How do I check the continuity on my gas range safety valve?

A:

I think its great that you are wanting to do some repairs on your own and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
November 21, 2012
A:

Thank you for your question and I understand your concern.

Since your gas range has a bake burner and a broil burner there will be two sets of terminals on the oven safety valve. The pair of terminals at the top of the valve is for the broil circuit and the two terminals on the bottom side is for the bake circuit. To test the safety valve for continuity; first disconnect power cord from the power source and then the wires from the gas valve. Place the Ohm meter leads across the two upper set of terminals and then across the bottom set of terminals and both sets should measure continuity. If one of the two sets do not measure continuity, the valve is faulty.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
November 23, 2012
See more answers
Q:

What does "F7" and "d6" fault code indicate on my GE range?

A:

The "F7" fault code is indicating a shorted START key or a shorted matrix. Determine if the problem is the key panel or the control board a technician would disconnect the ribbon connector and measure the flat cable using an ohm meter. Allow up to 1000 ohms when pressing a key.

There is no such fault code of d6 for your model range. I could not tell you what the d6 is indicating. All fault codes begin with the letter "F". It's possible that the d6 is and indication of a failed control board. I highly recommend calling a service technician to diagnose which component failed.

I recommend calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician
August 27, 2008

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show