Model #JGS8850ADW JENN-AIR Slide-In Range, Gas

  • Top Assembly
    3 Results
  • Body
    3 Results
  • Oven/base
    3 Results
  • Gas Controls
    3 Results
  • Door/drawer
    3 Results
  • Wiring Information
    3 Results
Find part by diagram >

Question and Answers

Q:

cooling fan not working oven shutting off with errors JGS8850ADW Jenn-air Slide-in range, gas

A:

Thank you for choosing SearsPartsDirect.com. I will be more then happy to assist you. Looking at the information and the error codes it dose look like the control board is going to need to be replaced. The correct part number for the control board for you JennAir JGS8850ADW is 74005740. If you are not comfortable doing this repair you can Click Here to schedule a technician or call toll free 1-800-469-4663. Hope this information has help you, any further questions or concerns please feel free to comment back, thanks.

Read More
Samantha A -
Sears Technician
May 28, 2014
A:

thanks for the reply. You said "control board", but the part you list is the touchpad/keypad. I've ordered the control board 74007217 74006387. Correct? Thanks

Read More
Enzo -
May 29, 2014
A:

The Control board did not resolve the fan issue. I do not seem to be getting the F1 F3 errors, but the cooling fan still does not come on. Is there a separate thermostat for the fan?

Read More
Enzo -
June 06, 2014
A:

and now i'm getting F1-8 ... any help would be appreciated.

Read More
Enzo -
June 09, 2014
See more answers
Q:

why is my jenn air range oven shutting off?

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within two business days but usually sooner. Thank you for using Manage My Life.

Read More
James -
October 19, 2011
A:

I recommend that you try to reset the control board by shutting off the house circuit breaker for the range to completely disconnect electrical power. Leave the power off for 5 minutes and then reset the circuit breaker to restore power.

Check to see if the control will work properly after this procedure.

If that does not help, then you can try to reset that control to the original factory settings as shown in the top of the image below.

If you reset the control and still have problems, you can run the diagnostic test shown in the image below. This may reveal a component problem. NOTE: Do not active the Bake and Broil relays for a long amount of time during that test.

If everything works in the diagnostic test program, then you probably have a bad electronic clock control board. There is a chance that you have the incorrect control board part installed in the range. Since you recently had the range serviced, I recommend that you contact the service company that repaired the range. If you had the range repaired by Sears, you can call 1-800-469-4663 (1-800-4MY-HOME) regarding that service. You can also schedule Sears service online through this website: Sears Home Services .

These initial tips may help you resolve this range problem. If you need more assistance, reply with additional details and the serial number of your range (the serial number is sometimes needed to obtain the correct parts).

Read More
Lyle W -
Sears Technician
October 19, 2011
See more answers

Top Parts