Model #JGRP20SEN1SS GE Wall Oven, Gas

  • Gas & Burner Parts
    3 Results
  • Control Panel
    3 Results
  • Body Parts
    3 Results
  • Door
    3 Results
  • Door Lock
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Range G.E. model jgrp20sen1ss, how to remove and install igniter for bake wb02x9154

A:

I understand that you want to remove and install your igniter. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below for you to view. I hope the link that I provided is helpful. Have a nice day.

Read More
Alina F. -
September 11, 2011
A:

Thank you for your question and I understand your concern.

The bake igniter is located under the floor of the oven. You will need to disconnect the power supply to the oven and then remove the oven bottom following the instructions in the image below.

The bake igniter will be fastened to the burner with one or two screws. The two wires connected to the bake igniter will likely connect to a quick disconnect plug. Disconnect the two plugs and remove the old igniter. Handle the new igniter with care. It is very fragile and can break very easily. The new igniter wires may have to be cut and then reconnected to the existing two wires using the two ceramic wire nuts. The ceramic wire nuts will likely come supplied with the new bake igniter. You may have to remove the storage drawer in order to access the quick disconnect plug.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
September 13, 2011
See more answers

Top Parts