Model #JGP636BEV3BB GE Counter Unit, Gas

  • Cooktop
    3 Results
  • Gas & Burner Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

gas valve JGP636BEV3BB Ge Gas cooktop

Q:

GE Gas Stove JGP636BEV3BB Clicks continuously

A:

I know that it can be very inconvenient for you not to have your range working properly. While you are waiting for an expert to respond I was able to locate some great information that could possibly assist you with your issue. I have added the link below. Hope this helps!

Read More
Yadira B -
November 19, 2012
A:

Thank you for your question and I understand your concern.

If just one of the 5 spark ignition switch is shorted, all 5 electrodes will spark. All the spark ignition switches should normally be open until the burner knob is rotated to the light position at which time it completes the electrical circuit to the spark module.

You test each one of the switches with the Ohm meter. You will likely find one the 5 switches shorted closed. It's not a faulty spark module.

I added a couple of images below to reference.

NOTE: Disconnect the power cord and I recommend shutting the gas supply off before removing the top.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
November 20, 2012
A:

Thanks Joey! That helps a lot. One question I have is that I couldn't see the switch in the diagram. Can you specify where it falls in there? Also, my wife noticed that if she turned one of the knobs a bit (about 1/4 of the way on, but not to the Lite position), it stops the clicking. We held flame to the burner and there does not appear to be any gas. We haven't tested if this would apply to the other 4 burners. Does this mean anything to you and your recommendation?

Read More
Drake -
November 20, 2012
A:

Drake: I circled the switches in the image I added below. Based on your additional information, the spark ignition switches sit over the stem of the gas valves and must stay stationary on top of the gas valve or it could cause the issue you are having. If the switch rotates out of position, it can cause your exact symptom.

Read More
Joey S -
Sears Technician
November 20, 2012
See more answers
Q:

How do I disconnect the burner bowl from the igniter? I have a GE gas cook top Model No. JGP636BEV3BB

A:

I can understand your concern over wanting to know how to properly disconnect the burner bowl from the igniter on your cooktop. I did some research and provided a link to a similar question and answer on our site. I hope this will give you a better idea on the next step to take until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
November 02, 2012
A:

Thank you for your question and I understand your concern.

There is a small little clip on the electrode that must be pried off before the electrode can be pulled up and off.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
November 03, 2012
See more answers

Top Parts