Model #JGC1536ADS JENN-AIR Counter Unit, Gas

  • Top Assembly
    3 Results
  • Body
    3 Results
  • Supplemental Information
    3 Results
Find part by diagram >

Question and Answers

Q:

How do you connect the module and the wires for the electric igniters inside the stove?

A:

Connecting wiring does require good directions or expert help. While you wait for the expert response, you might check the installation manual below for some help. I also added the parts diagrams from Sears Parts Direct. I hope this information helps make those connections.

Read More
Barbara H. -
June 07, 2012
A:

Ive gone through both of those already but they were no help. I need a specif diagram of how to connect the wires from the module of the stove to the electric igniter.

Read More
Efrain -
June 07, 2012
A:

You will normally need to remove the cook top from the counter to access the spark module and igniter wiring connections. Be sure that you shut off the gas supply and unplug the cook top before beginning that process. Here is a link for the installation guide that will help you pull out the cook top: Installation Manual for JennAir Cooktop JGC1536ADS . Remove the grates and burner caps before pulling the cook top out of the counter. Once you get that cook top pulled out, you should be able to remove the burner box (Key 1 in the second image below). I believe that you will find screws around the side of that burner box that attach it to the bottom of the cook top. That will give you access to the spark module (Key 7) and the igniter electrodes on the burner orifice holders (Key 6). The wires should have slide-on connectors that will slip onto the spades on the spark module and the igniter electrodes. I provided a wiring diagram in the first image in case you need it.

I hope that this is the information that you are looking for. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician install those wires, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
June 09, 2012
A:

I followed the diagram and got the cooktop to click but it turns on and wont stop clicking. I havent connected it to gas yet. Is there a reason for this? Does this mean I connected it wrong?

Read More
Efrain -
June 09, 2012
A:

Hell Efrain. That type of problem is normally caused by a failed burner switch that is stuck in an electrically "closed" position. You will probably need to find the bad burner switch and replace it to fix that problem. Be sure that you have electrical power disconnected from the cooktop when accessing internal components. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
June 11, 2012
A:

Thank you very much for your help!

Read More
Efrain -
June 15, 2012
A:

We are always glad to help. Let us know if you need more assistance.

Read More
Lyle W -
Sears Technician
June 15, 2012
A:

We are always glad to help. Let us know if you need mroe assistance.

Read More
Lyle W -
Sears Technician
June 15, 2012
See more answers

Top Parts