Model #JGB920SEC4SS GE Free Standing, Gas

  • Gas & Burner Parts
    3 Results
  • Control Panel & Cooktop
    3 Results
  • Body Parts
    3 Results
  • Door & Drawer Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Burner head JGB920SEC4SS Ge Gas range

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Marc -
March 13, 2013
A:

Thank you for your question and I understand your concern.

Based on the parts diagram and parts list, the burner heads are labled as small, medium and large. Since there is not an image of the right front burner you will need to identify if it's the same size as one of the other three burner heads. The right rear is has a small burner head, the left rear shows it to be a medium burner head and the left front has large burner head. I would have to suspect the right front is one of the three sizes. 

After further research, the tech sheet show that the left front and the right front burners are the same. The right front burner head is part # WB16T10024

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post

Read More
Joey S -
Sears Technician
March 14, 2013
See more answers
Q:

Oven does not seem to maintain temp (overshoot / undershoot) using convection better without convection Is bad ignitor possible

A:

This would appear to be a thermostat problem. First try to adjust the temperature per the owner’s manual. You will need to check the thermostat calibration. Place a good thermometer in the center of the oven and set the temperature to 350 degrees and let it cycle at least 3 times. You can adjust the thermostat plus or minus up to 35 degrees (see attached instructions). If the temperature is more than 35 degrees off, the control or sensor will need to be replaced. A resistance check of the sensor will need to be made, to determine if the sensor or the control has failed. A technician may be needed to make this check. If you need more assistance, additional details will be needed.

Read More
Scott D -
Sears Technician
June 21, 2010

Top Parts