Model #JDS8850BDS JENN-AIR Slide-In Range, Electric/Gas

  • Control Panel/top Assembly
    3 Results
  • Gas Controls
    3 Results
  • Body
    3 Results
  • Oven/base
    3 Results
  • Door (ser Pre 10)
    3 Results
  • Door (ser Pre 11)
    3 Results
  • Warming Drawer
    3 Results
  • Supplemental Information
    3 Results
  • Wiring Information
    3 Results
  • Wiring Information (french)
    3 Results
Find part by diagram >

Question and Answers

Q:

Jenn Air JDS8850BDS no display Jenn Air JDS8850BDS

A:

Thank you for your inquiry on your Jenn-Aire Range, Model: JDS8850BDS. From reviewing the details on your model, unfortunately there are no tips or tricks we could provide on how to keep a control board from going bad. It’s just something that can’t be control when it goes bad. 

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663.

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry 93 -
Sears Technician
April 24, 2015
Q:

My jenn air range #JDS8850BDS Key pads do not all work 1 to 6 do not respond, only 7 8 9 respond. I can not set temp. or clock any other using 1 to 6

A:

First check to see if those key pads have not simply gotten stuck. Tap on them to see if they might spring back. If they are not stuck, refer to the link I have provided below for additional information. The link does not match your model number but the causes would be the same. You will still receive an expert response from our team within a day or two. I hope this helps you and have a pleasant morning.

Read More
Henry -
September 24, 2012
A:

Thank you for your question and I understand your concern.

Based on your symptom and details; it could have loose connection at the flat ribbon connector on the electronic oven control that connects the touch panel/membrane switch/control panel to the oven control. It could also have a faulty touch panel or oven control. You can test the touch panel buttons for continuity with an Ohm meter.

I added an image below with the procedure of removing the control panel and it will show which pins/trace to measure continuity across for each key pad. For example; to check key numeral one you will place one Ohm meter lead on pin 2 and the other Ohm meter lead on pin 7 and then press and hold key pad number one. If the Ohm meter does not measure continuity, the key pad is faulty. NOTE: Disconnect the range from the power source before removing the control panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
September 25, 2012
See more answers

Top Parts