Model #ITW4400SQ0 INGLIS Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Controls And Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Question and Answers


Water won't shut off once washer basket is full


Washers are one of the main appliance in our home so when it starts to have problems it can be really annoying. While you are waiting on an expert to answer your question, a suggestion I have is to set service with a Sears technician. Hope this helps!

Read More
Dezeray S -
August 01, 2011

Thank you for your question and I understand your concern.

If the washer continues to fill after it begins agitating then it likely has a faulty water inlet valve.

If the water will shut off when you push the timer knob inwards it's not a faulty water inlet valve.

I'm guessing the air hose may have a hole chewed into the water level pressure switch air hose when it was in storage for 3 years; or it could have a faulty water level pressure switch or timer.

The first thing I would do is remove the cabinet and check the clear air hose connecting the water level pressure switch to the air dome on the side of the tub. Since it was in storage a little varmint may have chewed a hole the air hose. If the small amount air that is trapped in the air dome leaks the water level pressure switch will not trip in order to shut off the water or begin agitation.

I added a YouTube video showing how to remove the washer cabinet . The video is specifically going to show how to access and replace the motor coupler but of course you will not need to go that far. After removing the cabinet you will see the air hose connected to the air dome on the lower right side of the tub. Check the hose for any holes. I have feeling the hose was chewed by a little varmint. NOTE: Be sure to disconnect the power cord before servicing your washer.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
August 03, 2011
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show