Model #ISU98662 INGLIS Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

Top rack not working in Inglis dishwasher mod # ISU98662

A:

The dishes not cleaning properly can be a hassle. I am adding a link below to help you with your question while you wait for your expert response.

Read More
Joseph P. -
January 30, 2012
A:

I know that it can be very frustrating to have problems with the dishwasher. First, I recommend that you check for cracks or splits in the upper spray arm. Check the spray holes for deposits that could be blocking the spray pattern. Make sure that the top rack is pushed all of the way in so that the top spray arm docks in the rear inner feed tube.

Check the water level in the dishwasher. Start a cycle and allow the dishwasher to fill. Crack the door open to stop the cycle as soon as the filling stops. Open the door fully and look at the water level in the bottom of the sump. It should be within 1/4" to just touching the bottom of the heating element.

If it is, take 4 coffee cups and place them in the four corners of the top rack right side up, with nothing else in the dishwasher. Then run the dishwasher for 45 minutes. If the cups are not full of water, then you do not have enough water pressure going through. This means that you have a problem with the inlet valve, or the pump.

First check the water pressure and flow from the water line. To do this you will need to remove the line from the dishwasher and make sure there is enough pressure coming out. If it is, check the inlet screen on the valve, if it is clogged it will prevent the water from coming into the dishwasher. If this all checks ok, then you will need to check the pump. For this I would recommend that you have a technician diagnose and repair it.

If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
February 01, 2012
See more answers

Top Parts