Model #IPU98660 INGLIS Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

Dishwasher will not complete cycle

A:

It can definitely be frustrating when your Kenmore dishwasher does not complete the cycles. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below if you are interested in viewing. I hope the link that I provided is helpful. You can also visit Sears Home Services website to set service with a Sears technician.

Read More
Dezeray S -
June 28, 2011
A:

From the description you give my first question would be was the water hot.

The unit will stall at certain points of the cycle to heat the water. Two hours is about normal for most newer dishwashers.

When you opened the door the water should have been very hot.

If the water is not hot then most likely there is a heating fault. This could be an element, hi-limit thermostat or relay problem.

If the water is really hot then the control or thermistor might be at fault.

Please reply with the additional information and we'll go further with this problem.

Read More
Fred M -
Sears Technician
June 28, 2011
A:

Thasnk you Fred M. I will check the heating element and measure at what part of the cycle it has voltage applied. What is very hot? Above 180C? Allan

Read More
Al -
June 29, 2011
A:

The water should be heated till it is approximately 135F degrees. With the time your unit is taking either there is no water heat or there is water heat ant the control is not advancing out of water heat.

Read More
Fred M -
Sears Technician
June 29, 2011
See more answers

Top Parts