Model #H-64 THERMADOR Range Hood

  • 3 Results
Find part by diagram >

Question and Answers

Q:

I have a Craftsman circular SAW { model 315 108 320]-- from which I CANT REMOVE THE BLADE -- The screw (18) t came off easy as well as the washer(17)

A:

I know that it can be very frustrating to have equipment that does not work. While you are waiting for your expert answer, I have found a link that will provide a set of instructions on how to remove the blade. This includes pictures of what you need to do. I hope this will help.

Read More
aashe -
September 20, 2011
A:

Thank you for your question on the removal of the saw blade for the circular saw.

It sounds like this blade has been on the saw for some time and the blade support washer # 16 is rusted or corroded to the arbor shaft.

If you rotate and tap the blade sideways from the inside out it should come off the arbor shaft.

It is not screwed on.

Please let me know if the removal tip worked.

Sam A.

Read More
Sam A -
Sears Technician
September 22, 2011
A:

Sam Yoiu are a genious--It worked!!! Per your excellent advice, I tapped the blde from under neatgh and gradually i began to see th blade come upward towards me--and voila it came completely off- I have one further question--the blade that was on there had lots of teeth per inch--(very fine teeth) i was cutting some small limbs with it--I have another blade that has a lot less TPI--Should I replace the fine teeth blade with the less TPT blade to cut the wood limbs faster??? Again Sam thanks jesesd@aol.com

Read More
Jeses -
September 22, 2011
A:

Thank you for the update on the saw blade removal. BE VERY CAREFUL with using the saw in that application because with green wood or limbs of trees the can bind and kick back and cause physical damage to you. It sounds like you had a plywood blade on the saw. If you are going to use it in this type of cutting I would suggest a carbide green blade for cutting green decking material. It will have about 24 teeth on a 7 1/4 inch blade. I hope this will help. Sam A.

Read More
Sam A -
Sears Technician
September 22, 2011
See more answers