Model #GY398LXPT00 WHIRLPOOL Slide-In Range, Electric

  • Cooktop Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Oven Parts
    3 Results
  • Door And Drawer Parts
    3 Results
  • Internal Oven Parts
    3 Results
  • Top Venting Parts, Optional Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Whirlpool electric range #gy398lxps01: The range oven would not work, so I replaced EOC #9757475. Now the problem still exists. Can you help with a list of part

A:

That's great to hear that you went ahead took control and tried to fix the problem on your own. But you might want to look at the link down bellow where an expert provides further information on what else can be causing this range not to turn on.

Read More
celene -
January 27, 2011
A:

The first image below shows a wiring diagram of your range with the L2 leg of power to the elements traced in red. There is a thermal fuse in that circuit that would prevent both elements from heating. The thermal fuse is circled in green. I recommend that you shut off the house circuit breaker for the range and check that fuse. It is shown as Key 24 in the parts diagram provided in the second image. It should be under the cook top. If that fuse is blown, then the elements will not heat. You can check that fuse with a volt/ohm meter. Remove one wire and measure the resistance across the leads of the fuse. It should measure around zero ohms of resistance (continuity). If it measures Ol (open load or infinite resistance) then it is blown and will need to be replaced. You can conduct a brief test to see if the elements will heat with this fuse bypassed. Tape the wires that go to this fuse together with electrical tape. Reassemble the range and see if the oven will heat with this fuse bypassed. If it does then replacing this fuse will fix your range.

NOTE: Do not continue to operate the oven with this fuse bypassed. It is an important safety component that must be replaced.

The part number for the thermal fuse is 9759243. You can order it from the Sears PartsDirect website. Here is a direct link for that part: Thermostat .

These tips should help you resolve this oven problem. If you need more assistance, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 28, 2011
A:

i am presently working on a whirlpool range m#gy398lxpt00.all surface units work properly.problem lies with the oven.both elements will come on at the same time but cannot be turned off without unplugging the range.also the temp is stuck at 350 & cannot be adjusted.when plugged in clock illuminates along with PF in red .the only touch pad that works is bake.when pressed pf goes out & 350 illuminates in red.i had the electronic control out on on the bench.all components test good(i do consumer electronics repair for a living) & all solder looks good.i suspect the control panel is defective.is there a way to tell for sure as the electronic control could also be bad.

Read More
Anonymous -
February 02, 2011
A:

I do not find a pin out resistance check for the membrane keypad. The technical information that I have does not provide a procedure for checking the keypad. You will probably need to replace the keypad. If you continue to have problems after replacing the keypad, then the electronic control board will also need to be replaced.

Read More
Lyle W -
Sears Technician
February 02, 2011
See more answers

Top Parts