Model #GW395LEGQ6 WHIRLPOOL Slide-In Range, Gas

  • Cooktop/literature
    3 Results
  • Control Panel
    3 Results
  • Cooktop Burner
    3 Results
  • Broiler And Oven Burner
    3 Results
  • Door And Drawer
    3 Results
  • Oven Chassis
    3 Results
  • Rear Chassis
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a 2003 whirlpool gold accubake system range and the stove won't heat. The display is flashing E-1 F-1. What do I do?

A:

I know how important it is to have a good working range in your home so that you can create a great meal. While you are waiting for an expert answer, I did manage to find a link that will provide you with good tips about what may be causing your problem. Please keep in mind that the link describes a different model number than the one you have so I am adding a second link in where you can enter your model number and a parts list diagram will pop up. I hope my links are useful.

Read More
Joseph P. -
January 19, 2011
A:

Thank you for your question and I understand your concern. The fault code "F1/E1" implies an internal failure within the electronic oven control. The electronic oven control will need to be replaced. NOTE: Disconnect the range from the power supply before servicing your range.

I added an image below with the instructions for removing the oven control.

The electronic oven control (EOC) is part number #9753639 and can be ordered and shipped to you from Sears PartsDirect

Read More
Joey S -
Sears Technician
January 20, 2011
See more answers
Q:

What would cause my gas oven to barely produce any heat?

A:

Most likely the glow bar ignitor for the bake burner is weak and is not allowing the oven safety gas valve to open. This is why there very little heat in the oven. The ignitor is glowing red but not hot enough to safely ignite gas if the gas valve was to open. The Broil burner also uses a glow bar ignitor. Set the range to Broil and you will see the broil ignitor glow just like the Bake Ignitor is doing. Once the ignitor is glowing hot enough and it's pulling enough current it will cause the oven gas safety valve to open and ignite off the glow bar ignitor. You won't be able to see the Bake ignitor without removing the floor of the oven.

Since both the Broil and Bake ignitors are the same you can swap the Broil ignitor with the Bake ignitor and then test the bake operation. If the oven burner comes on then that would indicate the Bake igniter was bad.

I added an image showing the Broil ignitor (key#6) but it does not show the Bake ignitor. The bake igniter would have been shown next to bake burner (key#4).

To gain access to the Bake ignitor remove the oven bottom (key#8) and the screws (key#22), and (key#1).

NOTE: Be sure to disconnect power to the range before accessing the Bake Ignitor.

Read More
Joey S -
Sears Technician
September 03, 2008

Top Parts