Model #GU2451XTSB1 WHIRLPOOL Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

wet dishes

A:

Having problems with a Dishwasher can be very frustrating as well quiet a concern. I have taken the time to do some research on the Manage My Life website were I have found some information that you may find useful. While you are waiting for your expert to reply I have provided as couple links below if you wish to take the time to view. Hope you do find this information useful.

Read More
Priscilla V -
December 17, 2010
A:

Pvalde2 provided some links for previous answers in the above response. Those previous answers may help you determine the cause of your problem. As noted in the second link, the plastic dishes will normally not dry even if the heater is working since they don't retain heat.

If the glass and ceramic dishes are not drying even though the heating element is apparently working, you could have a problem with the rinse aid dispenser. Make sure that the rinse aid dispenser is full. Check your setting and make sure that it is appropriate for your level of water hardness. If you suspect that the rinse aid dispenser is not working, you can check it using the diagnostic test shown in the first image below. In the 12th interval of that test, the dispenser should be getting voltage from the control board. If the dispenser is not working, you could have a problem with the dispenser assembly, the wiring or the control board. The second image shows the wiring diagram and a strip circuit for the dispenser system. You can shut off the circuit breaker and use that information to check the wiring and the dispenser circuit. I don't recommend that you perform any live voltage checks on the dispenser system. That type of test should be conducted by a service technician. Here is a link for the Sears Service website in case you need it: Sears Home Services .

If you need parts, you can order them from the Sears PartsDirect website.

I hope that this information helps. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
December 18, 2010
See more answers

Top Parts