Model #GTUP270EM1WW GE Laundry Centers/Combos

  • Controls
    3 Results
  • Front Panel
    3 Results
  • Blower & Motor
    3 Results
  • Door
    3 Results
  • Cabinet (1)
    3 Results
  • Cabinet (2)
    3 Results
  • Cabinet (3)
    3 Results
  • Cabinet (4)
    3 Results
  • Cabinet (5)
    3 Results
  • Cabinet (6)
    3 Results
  • Tub, Basket & Agitator
    3 Results
  • Motor & Drive Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dryer shuts off immediately GTUP270EM1WW Ge Laundry center

A:

Thank you for choosing SearsPartsDirect.com and being a valued member.  I can certainly understand how frustrating it can be when your dryer is not working properly.

It sounds to me like the push to start switch is going bad. If you have to hold it to keep the dryer running, then the switch is not making the right contact.

 
WE4M416 is the replacement start switch.

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the unit before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
August 16, 2015
Q:

GTUP270EM1WW tub seal GTUP270EM1WW Ge Laundry center

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you.

Click here for videos. 

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the unit before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
August 16, 2015
A:
Natasha12 -
Sears Technician
August 16, 2015
See more answers
Q:

SPIN BASKET BALANCE GTUP270EM1WW Ge Laundry center

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you.


No, that is just the tub cover.
The suspension rods is what keeps the washer balanced. 

Suspension Rods 
To remove the tub suspension rods: 
1. Remove the cover assembly.
Note: In the following step, dampening straps are 
not present on some 24-in. models.
2. Disconnect 4 dampening straps from the tub 
cover by removing four 5/16-in. hex-head 
screws. (See Tub Cover.) 
3. Lift up on the tub and pull the suspension rod 
out of the slot in the tub. 


Cover Assembly
To remove the cover assembly:
1. Remove the front panel.
2. Remove the two 1/4-in. hex-head screws that 
attach the cover assembly to the washer.
3. Lift the cover assembly approximately 4 inches, open the lid, and then remove the 2 phillips-head screws that attach to lid lock.
4. Reach under the cover assembly, and then 
? rmly press in on the front lock tab to release 
the lid switch. Push it up from the opening in the 
cover assembly. 
5. Pull the cover assembly from the washer. 

Front Panel
The front panel is attached to the washer cabinet by 
2 bottom hooks and 2 top lock tabs.
To remove the front panel:
1. Insert a putty knife between the washer top and 
the front panel 4-1/8 inches from each side.
2. Press in on each lock tab and pull the top of the 
front panel forward.
3. Lift the front panel and remove it from the 
bottom 2 hooks.

WH16X10151 front rod.
WH16X10150 rear rod.

 You can also visit searpartsdirect.com for parts, diagrams, and repair information.

 

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
June 23, 2015

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show