Model #GTF1040AS0 GIBSON Residential Washers

  • Control Panel
    3 Results
  • Wshr Cab,door
    3 Results
  • Wshr Tub,motor
    3 Results
  • 134053100 Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Gibson front load washer does not spin. What could be the problem

A:

It's very frustrating having problems with your washer. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. I attached the link below for you to view. I hope the link that I provided is helpful. Have a nice day!

Read More
Yadira -
August 08, 2012
A:

You could have a problem with the timer in the console or with the speed control board next to the drive motor. A wiring failure or a problem with the motor could also cause this spin failure. A service technician will normally need to diagnose and repair that type of failure. The signals going to the speed control board will need to be checked using a timer chart. Live voltage checks would need to be conducted using a volt/ohm meter. The timer and the speed control board are both expensive components. That is why I recommend that you have a service technician diagnose the washer before you buy parts and attempt to fix it yourself. Here is a link for the Sears Service website: Sears Home Services .

If you are advanced in technical skills and you want to fix this washer yourself, reply to this thread and we will assist you further.

Read More
Lyle W -
Sears Technician
August 10, 2012
A:

Our Gibson washer, Model #GTF1040AS0, is not spinning on the spin cycle. I have used the supplied trouble shooting tech sheet. I have checked the fuse on the Speed Control and it is good. I checked the resistance on pins 1-2, 2-3, and 1-3. They were open, not indicating 3 Meg ohms on my meter as the tech sheet indicates. I believe I need a speed control.

Read More
Ron -
November 06, 2012
A:

I looked at the tech sheet for the washer and see that test that you conducted. According to the results of that test, the speed control board will need to be replaced in that situation. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
November 06, 2012
See more answers
Q:

Gibson Front Load Washer (gtf1040as0) - What is the cubic feet and RPM of drum?

A:

Hi Tim, We received your question I'm not finding any information at all about Gibson front load washer. An expert will be in contact by e mail within 24 hours. Thank you!!

Read More
Raquel F -
June 21, 2010
A:

Thanks for the reply. I would also love to know how much water is used as well.

Read More
Tim -
June 22, 2010
A:

This washer is a 3.1 cu. ft. model. The maximum spin speed is 1050 rpm.

Read More
Lyle W -
Sears Technician
June 24, 2010
A:

Lyle... appreciate your assistance with this. Thanks.

Read More
Tim -
June 24, 2010
See more answers

Top Parts