Model #GSD2920S48BA GE Dishwasher

  • Control Panel/door
    3 Results
  • Tub Assembly/racks
    3 Results
  • Motor-pump Mechanism
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Stops a few seconds after it starts. Sometimes just flashes on then right off again. GSD2920S48BA Ge Dishwasher

A:

 Thank you for your question and I understand your concern.

 
I looked up the control board located behind the control panel and found that the control board is no longer available. Your symptom could be caused by a loose wire connection in the power supply connected to the dishwasher rather than a faulty control board. I recommend disconnecting the power supply from the dishwasher by turning the house circuit breaker off for the dishwasher circuit. Remove the lower toe panel and electrical junction box cover and check the power supply wire connections. The power supply connections in the electrical junction box are normally connected with wire nuts. If the wire connections are loose or corroded, it can cause the symptom you're having. If the voltage supply and wire connections are good, then I suggest shopping for a new dishwasher. I hope this information was helpful.
 

Read More
Joey S -
Sears Technician
May 23, 2014

Top Parts