Model #GMC RHEEM Furnace/Heater, Gas

  • Model Number Notes
    3 Results
  • Vent Damper Housing Assembly
    3 Results
  • Blower And Heat Exchange
    3 Results
  • Complete Blower Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Homelink problem 13954990 Craftsman Garage door opener

A:

Thank you for being Sears’ valued member and for contacting SearsPartsDirect.com with your question about your Craftsman garage door opener model 13954990. I am so sorry you are having difficulty linking the new opener with the Homelink system in your car. I will be happy to help you with this. I have included the link below for HomeLink. 

The website will take you through the set up process once you have entered information about your car’s make and model. The site will give you step-by-step instructions and also includes videos to help you with the set up. I hope this answers your question. Thank you for choosing Sears, we appreciate your business. 
 

Read More
Rachel Morgan -
Sears Technician
December 15, 2014
A:

Thanks but none of this worked - I did every bit of that before I asked for help. The homelink worked just fine on the old Craftsman opener - the problem is not with the car. The box said it is compatible with Homelink - what do I do now?

Read More
Kevin -
December 15, 2014
A:

I am also having problems getting my vehicle to work with this garage door opener. I have a 2013 GMC Sierra pick-up which does not have the Homelink system. It has the Lear Car 2U Universal Remote System. When I go to the Lear Car 2U website, i am told the Craftsman system is not a compatible system. As with Kevin my old Craftsman opener (Model No. 139.5398511) worked fine with my vehicle. I have spent several hours researching this problem and it appears that I need a Car 2U repeater to make the GM universal remote work with the Craftsman system. Is this true?? Please respond with some sort of guidance.

Read More
Daniel -
March 25, 2015
A:

Daniel, I had to buy a repeater to get it to work. About another 50 bucks, and not happy that I had to do it. What you get is another antenna receiver that plugs in near the garage door opener head, and also another remote. You program THAT remote to your vehicle system and stuff the remote in the glovebox or somewhere. So when I push the homelink button now it fires the antenna box via the remote in the glovebox, which then fires the opener. A lot of extra expense and trouble for something that should already work. I will do more research next time before buying a Craftsman opener.

Read More
Kevin -
September 08, 2015
See more answers
Q:

GMC Gas Furnance #GMP075-3: The fan blows continuously, with no heating or cooling. Thanks for a list parts to examine & test to diagnoise and repair.

A:

I'm sorry to hear that you are having some difficulties with your furnace. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
Joseph P. -
October 18, 2011
A:

Thank you for your question. If the fan runs continuously, first check if the thermostat is set to auto or on. If it's set to on, the fan will run all the time and if the thermostat is set to auto, this could be a board problem. Locate the white, green and red wires from the thermostat and where they connect on the board. Disconnect power to the furnace and now remove the red wire from the board. Reconnect the power and if the fan continues to run, it will indicate the relay in the board has failed and the board will need to be replaced.

If the motor stops when the thermostat wire is removed, it will indicate a problem with the thermostat or the wires have shorted together somewhere, between the thermostat and the board. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
October 19, 2011
A:

I disconnected the thermostat and the blower comes on and then cycles off, as if it were being controlled by the thermostat. Very strange that it cycles even with the thermostat out of the circuit?

Read More
George -
August 22, 2015
A:

This all started because I had to replace the run capacitor... maybe that's why the run cap failed?

Read More
George -
August 22, 2015
A:

This all started because I had to replace the run capacitor... maybe that's why the run cap failed?

Read More
George -
August 22, 2015
See more answers
Q:

Replace Door Hinges. GMC275PDB4 Whirlpool Built-in electric oven

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you in locating the instructions to replace oven door hinges. 


Click here for videos. 

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
June 18, 2015