Model #GLGFS75DBA FRIGIDAIRE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

how do I install the front glass on my Frigidaire oven model # GLGFS75DBA

A:

Thank you for your question. To install the front door glass, the door will first need to be removed and laid down on the floor. Refer to page 18 in the owner's manual to remove the door. The door will now have to be taken apart to replace the glass. I'm attaching a picture of the door sections below. Pay close attention to how each section is in place, so you can put it back in the same manner. The bottom screws will need to be removed, so the trim can be removed. The back bolts that hold the door handle will also need to be removed, so the door can be taken apart. Now, with the handle bolts out, carefully turn the door over and you may be fortunate enough to just remove the front, without having to take the rear section apart. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
November 21, 2013
A:

I'm sorry about the image, I'm attaching it here. I hope this will help you.

Read More
Scott D -
Sears Technician
November 21, 2013
See more answers
Q:

burner won't light, what parts do I need? GLGFS75DBA Frigidaire Gas range

A:

With the burners on your range not working properly can be quite upsetting. While you are waiting for a detailed reply from the expert I have done some research on the Manage My Life website and have located a link similar to you issue. I have provided the link below. Hope this helps!

Read More
Anonymous -
October 11, 2012
A:

Thank you for your question and I understand your concern.

You did not clarify if the electrodes on the other 3 burners are sparking or not. If only one electrode is not sparking; the wire lead may have come loose from the electrode. If none of the electrodes will spark no matter which knob is turned to the light position, then it could have disconnected wire at the spark switches or at the spark module. The surface ignition switches are located over the stem of each gas valve. Each burner valve has spark ignition switch. The switches fits over the stem and the switch must remain stationary or the switch assembly will rotate instead of the inner portion which makes and breaks contact in order to complete the voltage supply to the spark module. I added an image below of the wiring diagram and schematic so you can see the spark igniter wiring circuit and an image with the general instructions for hinging the top open and removing the manifold cover. The spark module is likely mounted behind the panel on the back of the range. When any of the surface burner valves are turned to the light position, there should be 120 volts measured across terminal L and N at the spark module. If 120 volts is measured then I would suspect a failed spark module.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
October 12, 2012
See more answers

Top Parts