Model #GHDA670N20BB GE Dishwasher

  • Escutcheon & Door Assembly
    3 Results
  • Body Parts
    3 Results
  • Upper Rack Assembly
    3 Results
  • Lower Rack Assembly
    3 Results
  • Motor-pump Mechanism
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

GE Adora dishwasher; chamber doesn't fill with water during any wash cycle. Model# GHDA670N20BB. How can I fix it before calling for an expensive repair?

A:

A dishwasher is definitely something we depend on and when it begins to malfunction it can be a huge inconvenience. While you are waiting for an expert to respond, I have attached a helpful link below that may provide information to assist you with your question.

Read More
Yadira B -
October 16, 2012
A:

Thank you for your question and I understand your concern.

In order for water to enter the dishwasher, the water inlet valve assembly located under the dishwasher must have a water supply. When the control is calling for fill water, the control board must supply 120 volts to the water inlet valve and it must open to let water enter. There is a flood/safety switch connected in the electrical circuit of the water inlet valve that can open and break the circuit to the water valve. Located inside the dishwasher in the front left corner is the safety float. If the float is stuck in the up position, the dishwasher will not fill with water. In order to check the float, remove the dome covering the float. There is screw that is threaded up from the bottom of the tub into the float dome that must be removed before the float dome can be removed. There is also a switch located under the tub below the float that must close when the float is down in order to complete the electrical path to the water inlet valve. I recommend confirming the water is turned on and the float is not stuck in the up position. NOTE: Turn the power supply off before servicing and removing the lower access panel.

If the water is on and the float is not stuck, I strongly suggest calling a service technician with the proper tool and equipment to diagnose and repair your dishwasher.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
October 17, 2012
See more answers

Top Parts