Model #GD5SHAXNQ00 WHIRLPOOL Side-by-Side Refrigerator

  • Cabinet Parts
    3 Results
  • Refrigerator Liner Parts
    3 Results
  • Refrigerator Shelf Parts
    3 Results
  • Freezer Liner Parts
    3 Results
  • Motor And Ice Container Parts
    3 Results
  • Refrigerator Door Parts
    3 Results
  • Freezer Door Parts
    3 Results
  • Dispenser Front Parts
    3 Results
  • Air Flow Parts
    3 Results
  • Control Parts
    3 Results
  • Unit Parts
    3 Results
  • Icemaker Parts, Parts Not Illustrated
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

The indoor air cooling diverter , Where does it go in the fridge. GD5SHAXNQ00 Whirlpool Side-by-side refrigerator

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Sherman_G_Wallace -
Sears Technician
May 14, 2014
Q:

Why won't the ice eject from the icemaker?

A:

There could be a few reasons why the icemaker is not ejecting the cubes:

  1. The icemaker may not be cycling
  2. The mold heater could be open
  3. The optic boards could be faulty.
This ice maker can be manually cycled to help determine the problem. To cycle this icemaker, remove the front icemaker cover to access the module. There will be some marked test terminals on it (I'm sending a picture with instructions). Now using a well insulated jumper, place it between terminals T-H and it should start to cycle. Be very careful this is a hot (live) check. If it starts to cycle, remove the jumper after about 5 seconds and continue to watch it. If it does cycle completely and eject the cubes in the mold, it indicates the icemaker thermostat is defective and needs to be replaced. It would probably be better to replace the complete icemaker though. If it cycles but won't eject the cubes, this will indicate the mold heater is not working and the icemaker will need to be replaced. If it won't cycle, there may not be any voltage to the icemaker and this could be due to the optic boards. Some voltage checks will need to be made to determine this. A technician may be needed to make these checks.

Read More
Scott D -
Sears Technician
April 02, 2009

Top Parts