Model #GBS22KBPAWW GE Bottom-Mount Refrigerator

  • Doors & Shelves
    3 Results
  • Cabinet
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

ice maker lets in too much water

A:

Good morning.... I can understand your concern if your running too much water and it over spills into the freezer. There is a way to adjust your water amount into the ice maker. I did locate a link that will discuss your situation in greater detail. Though this link discusses a different model number, the mechanics are likely going to be very similar. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. I hope this link will help guide you as to what might be wrong with your ice maker over filling and have a nice day.

Read More
Henry -
April 15, 2013
A:

I know that it can be very difficult to have issues with your ice maker. This is normally due to the water valve but it could be due to the icemaker. First, try adjusting the water fill. This is done with the screw behind the front cover of the icemaker. I'm attaching a picture with instructions to make this adjustment. If the water still overfills, the valve will need to be replaced. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
April 16, 2013
A:

I took front cover off of ice maker, there is no ajusting screw. all I see is a circuit board and a couple of gears.

Read More
dale -
April 16, 2013
A:

Do you see any testing points like the ones in the image below? There is a different test for these.

Read More
AnneJ -
Sears Technician
April 16, 2013
A:

no I didnot see anything that looked like your diagram. there is a small motor and a small gear that the motor is turning it looks like then in front of them is a small circuit board and that is all I see.

Read More
dale -
April 16, 2013
A:

Then the problem you are having is with the circuit board. This is what will control the level and filling for the ice maker. It sounds like it will need to be replaced. If this is the case it would be better to replace the whole ice maker. It would be a good idea to have the unit tested first, but I woud suggest that you schedule service for this. Please let me know if you need anything else. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
April 19, 2013
See more answers

Top Parts