Model #GBD307PDQ09 WHIRLPOOL Built-In Oven, Electric

  • Lower Oven Parts
    3 Results
  • Upper Oven Parts
    3 Results
  • Oven Door Parts
    3 Results
  • Latch Parts
    3 Results
  • Internal Oven Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Top Venting Parts, Optional Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Control Board / Touch Pad issue with Whirlpool GBD307PDQ09

A:

Replacing the control board would seem like it should take care of all issues. The expert will review this specific model to offer a response. In the meantime I did locate a similar question that may provide some insight even though it is not the same model. I attached to the link below.

Read More
Barbara H. -
March 03, 2012
A:

Attached is a picture of the error code. Looking forward to hearing from the expert's response. Thanks

Read More
Anonymous -
March 04, 2012
A:

When you replaced that oven control board, you should have programmed the cavity size as shown in the image below. If not, this could be causing your problem.

If you need help programming that cavity size, reply with your serial number and the size of the oven (30" wide, 27" or 24").

If you already programmed the size and still have a problem with the touch pad buttons working, then you may need to replace that membrane keypad. You can order that keypad from the Sears PartsDirect website. The part number will depend on the color that you need.

Be sure that you shut off the house circuit breakers for the oven to completely disconnect electrical power before accessing internal components.

If you need more help, reply with additional details.

If you get to the point where you need to have a service technician diagnose and repair this control failure in the oven, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
March 06, 2012
A:

I am unable to program the cavity size as some of the keys you are required to press do not operate. I am not sure why the cavity size would have anything to do with the specific error message. Please elaborate.

Read More
Anonymous -
March 06, 2012
A:

What I really want to know is what the error code (n0F0 E0) indicates / means? Have you seen it before?

Read More
Anonymous -
March 06, 2012
A:

That nOF0 E0 indicates that no error codes are detected. That cavity size normally needs to be programmed to initialize that new control board. If you did not shut off the breaker for 5 minutes and then reapply power and try to program that size within 60 seconds of power up then I recommend that you attempt that procedure. If you still cannot program that size then you probably have a failed membrane keypad. There is not a diagnostic test procedure provided for that membrane keypad on your model of oven. Replacing that key panel would be the next step in troubleshooting your problem. You should then be able to program the cavity size and use the oven normally. I hope that this additional information helps. If you need more assistance, reply with additional details (including that serial number of your oven).

Read More
Lyle W -
Sears Technician
March 06, 2012
A:

Thanks. Got what I needed and will order a new key pad and go from there. I will report back my results.

Read More
Anonymous -
March 06, 2012
A:

Replacing the control panel (key pad) solved my problem.

Read More
Anonymous -
March 11, 2012
A:

Thanks for letting us know how this turned out. We are glad to hear that you got the oven fixed.

Read More
Lyle W -
Sears Technician
March 12, 2012
See more answers

Top Parts