Model #FRT18IL6DS6 FRIGIDAIRE Top-Mount Refrigerator

  • Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • System
    3 Results
  • Ice Maker
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Ice maker over fills tray. Water won't shut off.

A:

I can certainly understand how frustrating it would be after spending money and time replacing a recommended part to still have the same issue. While you wait for the expert, you can check a similar question from an appliance repair web site I found. Maybe it will help shed some light on this ongoing issue. I attached the link below. Hope this helps!

Read More
Barbara H. -
October 14, 2010
A:

I'm sorry you are still having a problem with this. If the water supply is turned off but starts flowing as soon as it's turned back on, it indicates a stuck water valve or short in either the icemaker or the wires. With the water turned off, disconnect the power cord and now turn the water back on. If water still flows, it indicates the valve is stuck and will need to be replaced. If no water flows, reconnect the power and if water now flows, disconnect the icemaker wire harness. If the water now stops, the icemaker # 5304458371 will need to be replaced. I hope this will help you.

Read More
Scott D -
Sears Technician
October 15, 2010
See more answers
Q:

Frigidaire Ice Maker won't shut off.

A:

There nothing like having a nice cold ice drink on a hot summer day but when ice maker doesn't work it can be very upsetting. While you are waiting on an expert to answer your question. I found this really great link on Frigidaire ice maker won't work. I attached the link below. Hope this helps! Good luck.

Read More
Dezeray S -
October 06, 2010
A:

Going from no water to, too much water can be frustrating. This type of problem indicates, the water valve has failed. The valve # 241803701 will need to be replaced. It's available at SearsPartsDirect . If you would like more assistance, additional details will be needed. Thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
October 07, 2010
A:

Please help. The expert answer is wrong. I paid $45.00 between part and shipping and am still having problem. Water to the tray will NOT shut off, it overflows the tray into the ice cube pan. I replaced the water valve and that is obviously not the problem

Read More
porsche guy -
October 14, 2010
A:

If the water still won't shut off, it indicates the icemaker is holding the valve open. To check this, the icemaker will need to be removed from the wall but not disconnected. To remove the icemaker, remove the top 2 screws above the mold and the 1 under it. Now just lay it down but do not disconnect it. Get a measuring cup and place it under the fill tube to catch the water when it fills. Now cycle the icemaker by removing the front cover and turning the small gear counterclockwise until the icemaker starts (see picture). Toward the end of the cycle it will fill, for approx. 8 seconds. If it continues to fill longer then this, disconnect the icemaker to make sure the water does stop. If it does stop, the icemaker # 5304458371 will need to be replaced. If the water continues and the valve has been replaced, it will indicate a short or the new valve is not working. In this case, I recommend having a technician check it. I hope this will help you.

Read More
Scott D -
Sears Technician
October 15, 2010
A:

But it is filling non-stop???? So when I remove the 3 screws and set it down I should then turn on the water, which will run non-stop. Then as it's running should I turn the gear counter-clockwise to try to get it to stop?? Thank you

Read More
porsche guy -
October 15, 2010
A:

Based on the information listed, it sounds like you have the water supply turned off and when you turn it on, water flows out of the fill tube. If this is the case, disconnect power to the refrigerator (pull the power cord). Now turn the water supply back on and if water still comes out, it indicates the valve is stuck and will need to be replaced. If no water comes out, disconnect the icemaker wire harness and reconnect the power cord. If no water comes out, now reconnect the icemaker harness and if water flows, disconnect the harness again. If the water stops now, the icemaker # 5304458371 will need to be replaced. I hope this helps you.

Read More
Scott D -
Sears Technician
October 15, 2010
See more answers

Top Parts