Model #FGX831CS1 FRIGIDAIRE Laundry Centers/Combos

  • Upper Cabinet/drum Heater
    3 Results
  • Motor/blower/belt
    3 Results
  • Control Panel
    3 Results
  • Lower Cabinet/top
    3 Results
  • Motor/tub
    3 Results
  • Transmission
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

hot spot on the insider of dryer drum

A:

Good morning... I can fully understand your concern regarding this hot spot issue. I did locate a link that will discuss this situation in greater detail. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. I hope this link will help guide you as to what might wrong with your dryer and have a nice day.

Read More
Henry -
December 20, 2012
A:

Hi, Thank you for asking this question and allow me to answer it this way.

Was the drum just hot or was it hot at the rear wall? This is a gas dryer and does not use an element for the heat, which comes into the drum from the rear and exits at the front through the door and lint screen. In all cases I would recommend you check the exhaust vent and the lint screen to make sure the heats is not obstructed on its way to the outside. In the case of the screen, check to make sure that when held under a water faucet it does not hold the water. Reply below to give me more information.

I hope this answer is useful and that it helps you correct the problem with your appliance.
Thank you for using ManageMyLife.

Read More
Bill__W -
Sears Technician
December 20, 2012
See more answers
Q:

laundry center

A:

When making some adjustments on an appliance, Manage My Life is here to help. While you are waiting for your expert answer, I did manage to find a link in where you can enter your appliance model number and a parts list diagram will pop up to guide you with your project. I hope my link is useful.

Read More
Joseph P. -
July 27, 2011
A:

I'm surprised the unit will not fit through your door.

Taking the unit apart and separating the dryer from the washer is not a solution to this problem.

The dimensions in the image below should help with this problem. Notice the width side to side is 27 inches while the front to back dimensions is 30 13/16 inches.

I would think the 27 inches would fit though most doors.

Removing the door of the house would give you another inch of space to work with.

Let me know the width of the door your trying to move it through and we'll see if you have any other options.

Read More
Fred M -
Sears Technician
July 30, 2011
See more answers
Q:

What part do I need for my Frigidaire dryer?

A:

Having to wonder what parts are needed fort your Dryer is frustrating. While you are waiting on an expert to answer your question, a suggestion I have is to visit Sears Parts Direct website to speak with a Sears associate to find out what parts are needed. I have attached the link below. Hope this helps!

Read More
Dezeray S -
March 14, 2011
A:

Thanks, Dezeray--I started there, and a very nice parts specialist sent me here! I have to be very sure I'm getting the right part for the problem, because the appliance is is Central America, and I am sending it. Thanks for your suggestion--I'll go back there once I'm sure I have located the correct part. Helene

Read More
Helene -
March 14, 2011
A:

Thank you for your question and I understand your concern.

There is a little timer motor attached to the timer assembly that requires 120 volts in order for it run and advance the timer. The timer assembly will likely need to be replaced but in order to properly diagnose the symptom will require checking and verifying the voltage to the little timer motor. The voltage supply will need to be checked across timer terminal (TM) and timer terminal (C) for 120 volts. If voltage is present and timer is not advancing, replace the timer assembly.

I added an image below of the dryer wiring diagram and I traced out the circuit to the timer motor when the timer is set to "Timed" dry. The timer is part #5303297139 which can be ordered from Sears PartsDirect

NOTE: I do not recommend checking the voltage unless you have experience and feel safe and confident in doing so, otherwise I recommend calling a service technician to diagnose and repair your laundry center.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 15, 2011
See more answers

Top Parts