Model #FGF326KSB FRIGIDAIRE Free Standing, Gas

  • Backguard
    3 Results
  • Burner
    3 Results
  • Body
    3 Results
  • Top/drawer
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

Oven ignitor voltage FGF326KSB Frigidaire Gas range

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand your frustration when there is trouble with the gas range.
 
Glad to help out.   Im  looking at your Frigidaire Gas range model number FGF326KSB.

How to test gas ignitors for ranges:
 
1.  Unplug the oven from the wall for your safety.
 
2.  Lower the oven door.  Sometimes best to have more room and just remove it.
 
3.  Remove the oven racks from inside.  Remove the lower panel when testing the bake ignitor.
 
4.  Remove the burner shield by taking out the screws that secure it to ignitor first.
 
5.  Next take out the screws that hold the ignitor.  Pull the ignitor away from the oven wall.
    Unclip the wire connector.  If the wire connector is not accessible, remove the back rear
    panel to the oven, or remove the bottom storage drawer to access the wire connector.
 
6.  Get a multimeter to the lowest setting so you can measure the Ohms of resistance.  Calibrate
    the meter. Refer to your meters instructions 
 
7.  Place one of the terminals on the ovens bake/broil ignitor's terminal with one of the multimeters 
    probes.  Then touch the other terminal with the other probe.
 
8. On a Frigidaires says that the resistance should show anywhere from 50 to 150 ohms.  Your ignitors reading 176 ohms and therefore sounds like it should be replaced.

Please "RESUBMIT YOUR QUESTIONS IF THERE IS ANY OTHER PROBLEMS".

Thank you for your understanding in this matter and I hope we can help you with your future questions and repairs.  Thank you for choosing Sears and using our SearsPartsDirect.com.
 

Read More
Larry L -
Sears Technician
April 09, 2014
A:

thanks for your quick & professional reply. where I'm confused at is why there's only power to the ignitor for three seconds.

Read More
John -
April 09, 2014
A:

thanks for your quick & professional reply. where I'm confused at is why there's only power to the ignitor for three seconds.

Read More
John -
April 09, 2014
A:

thanks for your quick & professional reply. where I'm confused at is why there's only power to the ignitor for three seconds.

Read More
John -
April 09, 2014
A:

thanks for your quick & professional reply. where I'm confused at is why there's only power to the ignitor for three seconds.

Read More
John -
April 09, 2014
A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand the 3 seconds either.   I figure it isn't getting the spark to ignitor or it isn't holding it as it should.    

Good luck

Please "RESUBMIT YOUR QUESTIONS IF THERE IS ANY OTHER PROBLEMS".

Thank you for your understanding in this matter and I hope we can help you with your future questions and repairs.  Thank you for choosing Sears and using our SearsPartsDirect.com.
 

Read More
Larry L -
Sears Technician
April 09, 2014
See more answers

Top Parts