Model #FFU14F5HWA FRIGIDAIRE Upright Freezer

  • Door
    3 Results
  • Cabinet
    3 Results
  • System
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

have a FFU14F5HWA upright freezer that quit working and the display is showing some weird letters

A:

if you can give us the letters, we can tell you what the code means and try to troubleshoot how to fix it!

Read More
Ben R -
June 21, 2011
A:

I'm sorry that you are having some difficulties with your Frigidaire Freezer. I did a little research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links will help until your expert can respond.

Read More
James -
June 21, 2011
A:

ok some more info i found out it was reset to show room mode i got it in service mode and the code it returns is 0 1 3 - (if using the GE service manual from a friend 0=21cuft dont know the rest but it is a 14 cuft unit) while in service mode if i press the up/cooler arrow the compressor will run and seems to be cooling light still not coming on, correction light switch was stuck any info will be good as i am not any near a Frigidaire service rep Thanks for Any help

Read More
shane -
June 21, 2011
A:

I'm sorry you are having this problem. There is no code for 0 1 3 for this board. This would indicate a board failure. The board # 297241800 will probably need to be replaced. First, you can try resetting the board. This is done by disconnecting the power for 30 seconds and then reconnecting it. Also make sure the unit is plugged into a properly grounded 3 prong wall outlet. If this code still appears, the board will need to be replaced. It's available at SearsPartsDirect . I hope this will help you. If you would like more assistance, any additional details will be helpful and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
June 23, 2011
A:

Thank You ALL for your help. i have ordered a new control board, and will update you on the results when i get it

Read More
shane -
June 26, 2011
A:

hi all sorry for the delay in my re-posting , i replaced the controller board and solved the issue Thanks ALL for your help

Read More
shane -
July 13, 2011
See more answers

Top Parts