Model #FED367CETD FRIGIDAIRE Drop-In Range, Electric

  • Backguard
    3 Results
  • Top
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Wiring Diagram (1)
    3 Results
  • Wiring Diagram (ii)
    3 Results
Find part by diagram >

Question and Answers

Q:

Why did my Frigidaire drop-in/slide-in electric range malfunction while self cleaning?

A:

The F30 error code does indicate that you have a problem with the oven temperature sensor probe on this type of Frigidaire range.

You may be able to unlock the oven door by shutting off the breaker to the range and then pulling it out so that you can access the back panel. You can view a parts list diagram of the range on the Sears PartsDirect website. Pull off the back panel to access the door latch assembly. If you can disconnect the latch rod from the door latch assembly, you may be able to manually unlock the oven door and open it.

With the door open, you may be able to remove the oven temperature sensor probe and check it for resistance. You should see screws in the back inside wall of the oven cavity that secure the oven temperature sensor probe in place. (If not, the sensor probe will need to be accessed from the back of the range.) Remove the screws that secure the probe inside the oven (with the breaker still off) and carefully pull the probe inside the oven cavity until you encounter the wire harness disconnect plug. Unplug the sensor but do not let the wire harness shrink back through the back of the oven cavity. Check the resistance of the oven temperature sensor probe. You should measure about 1100 ohms at room temperature. Since you are getting the F30 error code, you will likely measure extremely high resistance or an open load. If the sensor is bad, replacing it will likely fix this oven problem. You can order a new sensor from the Sears PartsDirect website. Use your model number to order the correct part.

If the resistance of the temperature sensor is normal, then you likely have a bad electronic control board or you could have a break in the wiring harness between the sensor and the control board. I recommend that you have a service technician diagnose and repair this type of problem. Here is a link for the Sears Service website in case you need it: Sears Home Services .

If you need more help, resubmit your question with additional details and the full model number of your range (if you can find it once you get the door open).

Read More
Lyle W -
Sears Technician
March 30, 2010

Top Parts