Model #FEB27S5DBB FRIGIDAIRE Built-In Oven, Electric

  • Control Panel
    3 Results
  • Body
    3 Results
  • Door
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

need to replace gasket FEB27S5DBB Frigidaire Electric oven

A:

Thank you for being Sears’ valued member and for contacting SearsPartsDirect.com with your question replacing the oven door gasket on your Frigidaire oven model FEB27S5DBB. I will be happy to help you with this.
 
To complete this repair you will need a pair of needle nose pliers. Start by pulling out one of the ends that is tucked into the inner bottom of the door. Next you will need to pull the old gasket out. There will be a series of t-pins that fit into openings around the door. You should be able to work your way around the door pulling on the gasket to release the t-pins. If pin pulls free of the gasket, just be sure to remove it from the door before you install the new one.

To install the new gasket, start with one of the t-pins by the end of the gasket and push it into the t-pin hole closest to the where the end of the gasket pushes into the door. Work around the door pushing the t-pins in to the holes. Make sure they are inserted completely. The t-pins narrow as you push them through the opening and should “pop” open once it past the hole to hold the gasket in place. Once you have all of the t-pins in place you will need to use the needle nose pliers to push the gasket ends in to the door. I have included the link below for you to view some videos on installing the gasket. 

I hope this answers your question. Thank you for choosing Sears, we appreciate your business. 
 

Read More
Rachel Morgan -
Sears Technician
April 01, 2015
Q:

I need to know how to install an element in my oven.

A:

Range and oven repair can be a good home project with tools, knowledge and good instructions. The expert will review and provide step by step instructions. If you do decide that you would prefer to turn this repair over to the professional, I attached the link to Sears Home Services below. I hope this link helps if needed.

Read More
Barbara H. -
February 17, 2012
A:

Thank you for your question and I understand your concern.

The bake and broil elements are secured to the back of the oven cavity with screws. Open the door and remove the oven racks and disconnect the oven from the power supply by shutting off the two house breakers dedicated for the oven. Remove the screws securing the bake and broil elements and pull the element out slowly until you have access to the wires connected to the terminals of the elements. Disconnect the wires from the elements by pulling on the metal female terminal and NOT by pulling on the wire. Position the wires so that they do not recoil back through the small opening. Reverse the procedure to install the new bake and broil elements. NOTE: Be sure to disconnect the power supply from the oven before servicing.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
February 17, 2012
See more answers

Top Parts