Model #FDEB34RGS2 FRIGIDAIRE Residential Dryer

  • Dry Cab,heater
    3 Results
  • Frnt Pnl,door
    3 Results
  • Control Panel
    3 Results
  • Motor,blower
    3 Results
  • 131953900 Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

dryer fuses

A:

I know it can be very frustrating to have an appliance you depend on break down. Managemylife.com is always a great resource to find the answers to just about anything. I did some research for you at Managemylife and found an expert answer to a similar question that may help until your expert can respond to your specific question. I hope this link will assist you in this repair.

Read More
James -
February 22, 2012
A:

Thank you for your question.

I will be happy to assist you. The dryer does not have any internal fuses. I recommend checking the power to the dryer first. Turn the breakers off then back on. If the dryer still will not work, you will need to check the voltage at the outlet. This will require the use of a volt ohmmeter. If you have a meter, use the image below to check the outlet. If the outlet checks out ok please reply below with more details of the problem, you are having. I.E. The dryer will run but will not heat or will not do anything at all.

I hope this is helpful. Please let me know if you need further assistance.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
February 22, 2012
A:

Thank You Mark---The dryer runs. Just no heat. It did trip the breaker, but when I reset that, I got no heat. So, if it's the heating element do I have to replace the whole element housing or just the element itself??

Read More
robert -
February 22, 2012
A:

Thank you for the reply. If you have a meter, I recommend checking the voltage at the outlet first. This will ensure you have the proper voltage before replacing any parts. Even if the dryer runs you could still have a problem with the voltage. If the voltage is ok, you will need to unplug the dryer and take it apart. Once it is apart visually, check the heating element. It should not have any breaks in the wire. If you find the element is broke, it should be replaced. If the element looks ok, I recommend removing one of the wires from the element and checking the continuity of the element. If you get a reading, the element should be ok. Next, remove one wire on the high limit and check the continuity. If you do not get a reading, the high limit is defective. If the high limit is fine, remove the orange wire on the control thermostat and check continuity from the terminal where you removed the wire to the orange black terminal. If you do not get a reading, the control thermostat is defective. I hope this is helpful. Please let me know if you need further assistance. Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
February 25, 2012
See more answers

Top Parts