Model #FDB878GCS0 FRIGIDAIRE Dishwasher

  • Dishwasher
    3 Results
  • Console
    3 Results
  • Detergent Cup Dispenser
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Motor
    3 Results
  • Frame
    3 Results
  • Rack
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

Dishwasher - not rinsing FDB878GCS0 Frigidaire Dishwasher - 5995262523

Q:

So, for an FDB878GCS0 dishwasher-Reinstall pesky filter housing cover?

A:

I understand your concern toward wanting to install a cover on your dishwasher and I will be happy to help you. While you are waiting for an expert answer, I did manage to find a link that will provide you with more information about your problem: http://www.managemylife.com/mmh/questions/160457-how-do-i-remove-the-filter-assembly-in-my-dishwasher. I hope my link is useful.

Read More
Joseph P. -
October 28, 2010
A:

thanks but wrong model/brand

Read More
MichaelTrevithick -
October 28, 2010
A:

The tab on the filter should fit into a slot. To remove the filter you had to lift up on the filter where the notch is located and rotate it CCW to remove.

If you place the filter and rotate it clockwise slowly the tab should drop into place.

I hope this helps. You can reply with any additional details or questions for further assistance.

Read More
Fred M -
Sears Technician
October 29, 2010
A:

Well, I can get it to "drop into place"-what I can't do is to get it LOCK into place,and it was locked it place when I took it off-very much as you indicate. So I can get in on, rotate it so that it lines up corecty, but not so that it is firmly locked on as it was when I started. So, again, I think I will try a sealant to glue it down. Any other thoughts? Thanks

Read More
MichaelTrevithick -
October 29, 2010
A:

Sometimes the tab breaks but the it really shouldn't matter. I wouldn't suggest using glue. The tab was often broken but it really doesn't make a difference. As long as the cover is in place it should be okay.

Read More
Fred M -
Sears Technician
October 29, 2010
A:

I don;t know-it was pretty tightly held on there when I went to take it off-required a flathead screwdriver and a good deal of pulling and prying-and then there is a rubber gasket in a groove around the filter itself where the cover fits on-why would that be there is just "in place" is ok? It's puzzling to me, really. Thanks.

Read More
MichaelTrevithick -
October 29, 2010
See more answers

Top Parts