Model #FAQG7072LW0 FRIGIDAIRE Residential Dryer

  • Cabinet/drum
    3 Results
  • Front Panel/lint Filter
    3 Results
  • Controls/top Panel
    3 Results
  • Motor
    3 Results
  • Burner
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dryer not heating

A:

Having a properly working dryer is very important. The dryer not heating can be very frustrating.I found some information for you that I am hoping will help you out. Please click here:[Dryer Not Heating]. Your expert will also help answer your question. It may take two business days for your expert to reply. To better help you, I would like to suggest adding the model number of the dryer. If you would like to look into Sears doing the repair here is a link for Sears Home Services. I do hope that everything works out.

Read More
Marc -
June 05, 2013
A:

Thank you for submitting your question. I understand your concern and I will be happy to assist you. Marc has provided you with good information. There are several parts that aide the dryer in heating. If the gas dryer is not heating you could be experiencing an issue with the thermal fuse, operating thermostat, high limit thermostat, thermal cut-off or the burner assembly which consist of the igniter and the gas coil valves. The ignitor must have 110-120 volts supplied to it or it will not glow. The ignitor has to glow before it'll cause the gas valve to open and have burner ignition. If you have an ohms/volt meter you can test all these parts for the proper continuity to see which as failed. You'll want to disconnect both wires from the components and test them at room temperature for a proper reading. For further repair and part assistance, please reply back to this thread with the complete model number of your Frigidaire gas dryer. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
June 07, 2013
A:

Model #FAQG7072LW0 Thanks a lot for the sent info. I checked the continuity on the thermostat(s) and it seems fine, not sure if a certain ohms read is necessary, but there's continuity. I've already replaced the coils, and am currently waiting for an igniter to arrive. If that doesnt cut it, any further suggestions? other than a new dryer??

Read More
Fernando Solis -
June 07, 2013
A:

Fernando, the thermal fuse, operating thermostat, high limit thermostat and thermal cut-off; should have a reading of zero (closed) ohms. If the any of those parts read 1 or infinity, then it needs to be replaced. Your ignitor should have a reading of 40 ohms or as stated above measure 110-120 volts. If these parts all test good, then the issue could be with the timer, motor or wiring. I hope this helps. Please let me know if I can assist further.

Read More
Tykara -
Sears Technician
June 07, 2013
See more answers

Top Parts