Model #ETW4300TQ0 ESTATE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Controls And Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Question and Answers

Q:

My washer stops working after wash cycle is almost done ETW4300TQ0 Estate Residential washers

A:

Thank you for Choosing SearsPartsDirect.com. I defiantly understand the frustration with having a washer not finish all the cycles. I will be more then happy to assist you.

Looking at the information for Estate washer model ETW4300TQ0, If the washer is not finishing cycles not advancing to the next. The issue would be the timer on the unit.

The timer is the brain of the washer. It controls everything in the cycle. In addition to telling the motor when and which way to run, it tells any clutch solenoids when to engage, the fill valve when to open, dispenser solenoids when to open, etc.

Took look at the information and placement of were the timer is located on diagram under key#9 Click here. Also for pricing and ordering Click here

If you are not comfortable doing this repair you can Click Here to schedule a technician or call toll free 1-800-469-4663

Hope this information has help you, any futher questions or concern please feel free to comment back. Thanks.

Read More
Samantha A -
Sears Technician
May 07, 2014
Q:

Washer Fills but wont run ETW4300TQ0 Estate Residential washers

A:

Thank you for choosing SearsPartsDirect.com. I am sorry to hear that your washer will not agitate or drian. I know how upsetting a broken washer can be. I know I don't have time to take my clothes to the laundrymat. Based on your description sounds like 1 of 3 things could be wrong. The lid switch is a good possibility. The other is the motor coupler. The is a small round rubber coupler that gets worn from the inside-out and eventually looks like a broken belt. The last possibility may be a defective gear case. The best way to have the gear case tested is to have a technician go out and take a look.

If you would like a Sears technician to complete the repair, you can set up service at www.SearsHomeServices.com or by calling 1-800-469-4663.
I hope this helps you. Have a great day.

Read More
Samantha A -
Sears Technician
March 25, 2014
Q:

Spin cycle ETW4300TQ0 Estate Residential washers

A:

Thank you for your question and I understand your concern.

Based on your symptom and details, it sounds like a worn clutch assembly.  In order to access and replace the clutch assembly will require removing the washer cabinet from the washer base. The drain pump, motor, agitator and the gear case must be removed to access and replace the clutch assembly.

I added three images below to reference. Use the first image to release and place the control panel in the service position. The second and third image shows how to remove the pump, motor and gear case with instructions for the clutch replacement procedure. To remove the agitator, pry the cap off from the top of the agitator and then remove the bolt down in the center. Pull the agitator up and off by grasping the bottom half of the agitator and not by pulling up on the augur.

The clutch assembly part #3951311 for the Estate model  washer  ETW4300TQ0 is part #3951311 which can be ordered from Searspartsdirect.com

NOTE: Disconnect the power cord from the power source before servicing. 

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.

Read More
Joey S -
Sears Technician
September 24, 2013

Top Parts