Model #DU925SCGQ2 WHIRLPOOL Dishwasher

  • Frame And Console
    3 Results
  • Inner Door
    3 Results
  • Tub Assembly
    3 Results
  • Pump And Motor
    3 Results
  • Upper Dishrack And Water Feed
    3 Results
  • Lower Dishrack
    3 Results
  • Miscellaneous
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Assembling the new-style lower rack for the Whirlpool DU925SCGQ2 dishwasher

A:

I think its great that you are wanting to do some repairs on your own and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your repairs while you wait for your expert response.

Read More
Joseph P. -
November 01, 2012
A:

Thank you for your question and I understand your concern.

I'm sorry but the dish rack and the majority of most parts do not come with installation instructions. I wish the rack would come with instructions but it doesn't. It appears the lower rack comes with 4 sets of rollers, 3 plastic clips and a pivoting tine row. Two of the clips are used to support the pivoting tine row at each end which the tine row will pivot. The third part is a clip that is used to hold the pivoting tine row in the up or down position. I added an image below showing the location of where the tine row should mount as well as the pivot points and the piece that clips on the side of the rack to lock the tines in an up or down position. I hope this helps.

Read More
Joey S -
Sears Technician
November 03, 2012
A:

Hi. I have the same part, but mine came with a part (latch?) that is different than the one in your photo, Joey. I have attached a photo of my part, from 2 different angles. Does it attach in the same spot as the one in your photo? Thanks! Margaret

Read More
Margaret -
April 22, 2013
A:

Margaret: It appears by the image you provided it looks like a tine row clip that is used to keep the swing up tine row up in position. The clip would need to be clipped on the as shown in the image. It will need to be positioned so that when you raise the tine row up it would lock into the clips. If you run into a problem, I recommend stopping by a Sears store and looking at one of the dishwasher racks in a similar model dishwasher and it may help you understand exactly where it will snap onto. There are just so many little different changes in the racks, it would be near impossible to say exactly where this specific clip may fit. I hope this helpful.

Read More
Joey S -
Sears Technician
April 23, 2013
See more answers

Top Parts