Model #DU1300XTVB1 WHIRLPOOL Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Fill, Drain And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Heater Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Lower Rack Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Whirlpool Quiet Partner II Dishwasher stops a few minutes into cycle and does not drain du1300xtvb1

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your dishwasher and I do understand your frustration. Glad to help out. I'm looking at your model number du1300xtvb1and from your description I would suspect and issue with the control board. First test the door switches item 10 and verify that they are working properly. Here is a link for a video that may help with additional troubleshooting. I have included a link to our Parts Direct page where you can purchase the part you need to complete your repair. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
January 12, 2015
A:

Thank you Sherman. I had pretty much come to the same conclusion but wanted a second opinion before I started ordering parts. I really appreciate your time and effort.

Read More
Boomer -
January 12, 2015
See more answers
Q:

doesnt finish cycle DU1300XTVB1 Whirlpool Undercounter dishwasher

A:

Thank you for choosing SearsPartsDirect.com. I will be more then happy to assist you. Based off your description, it does sound like the door switch or latch needs to replaced to provide a proper seal or contact. This also might indicate a motor problem or even a door switch problem. There are a couple of things you can try to narrow the cause of the problem down. You can try the Rinse Only cycle. It is only about 12 minutes long and should just fill, wash and drain.  I recommend testing the door switches on the dishwasher to verify the part. You will need an ohms/volt meter for this testing. The switches may be bad or just have a loose connection. If you are not comfortable doing this repair you can Click Here to schedule a technician or call toll free 1-800-469-4663. Hope this information has help you, any further questions or concerns. You will have to post a new question because at this time I can not reply to any comments. Aging, Thank you for choosing SearsPartsDirect.com.
 

Read More
Samantha A -
Sears Technician
May 30, 2014

Top Parts