Model #DU1100XTPS3 WHIRLPOOL Dishwasher

  • Door And Panel Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Door And Latch Parts
    3 Results
  • Lower Washarm Parts
    3 Results
  • Heater Parts
    3 Results
  • Fill And Overfill Parts
    3 Results
  • Tub And Frame Parts
    3 Results
  • Pump And Motor Parts
    3 Results
  • Upper Rack And Track Parts
    3 Results
  • Upper Wash And Rinse Parts
    3 Results
  • Lower Rack Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

The "clean" light on my Whirpool dishwasher is blinking green. What can I do to trouble shoot the problem or fix it.

A:

I'm sorry to hear that you are having some difficulties with your Whirlpool Dishwasher. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
James -
November 02, 2011
A:

Thank you for your question.

The clean light flashing fault code indicates that the control board did not detect a 2 degree F increase in the water temperature if the initial inlet water temperature was greater than 90 degrees. It will also trip if a 4 degree increase is not detected when initial inlet water temperature is less than 90 degrees.

Possible causes that can keep the water from properly heating include:

  • Heating element is bad.
  • Wiring to the heating circuit is loose or broken.
  • Thermostat (thermistor) is bad. Wiring to the thermistor is bad.
  • Neutral side of the door switch is bad.
  • Water not coming in or a lack of water.
  • Siphoning of water during filling due to improper drain hose installation.

You can reset the control by running the diagnostic test cycle. Start this cycle by pressing the following buttons in this order: HEATED DRY, NORMAL WASH, HEATED DRY, NORMAL WASH. The buttons must be pushed within 5 seconds. After pushing these buttons, all the control lights will turn on and then the dishwasher will complete a short test cycle. After the test cycle, the control will be reset.

You can start a new cycle and crack the door to stop the cycle after the filling is complete and before the spray starts. Open the door and check the water level in the tub. The water should be within 1/2 to just touching the bottom of the heater element.

Check the heater element. If it is not heating, disconnect electrical power and check the wiring. If the heater element is bad, it will need to be replaced. If not, your clean light fault code will return.

If you reset the control and the fault does not repeat, you should be able to continue to use the dishwasher. Monitor the water fill and the heating circuit for problems.

Please feel free to reply below with more details if you need further assistance.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 03, 2011
See more answers

Top Parts