Model #DSXH43EF0WW GE Residential Dryer

  • Controls & Top Panel
    3 Results
  • Front Panel & Door
    3 Results
  • Cabinet & Drum
    3 Results
  • Motor
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Squeaking Dryer DSXH43EF0WW Ge Electric dryer

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina -
February 01, 2013
A:

The squeaking noise could be a few different things but one kit will solve all your problems. I recommend you purchase a dryer maintenance kit, it includes 1 belt, 4 support rollers, 1 pulley assembly, 9 tri rings and 1 washer. The squeaking could be caused by a bad belt or rollers. By getting this kit you will solve all these problems. I have attacthed a link to www.searsPartsDirect.com were you can complete your order.

 

http://www.searspartsdirect.com/partsdirect/part-number/4392067/0026/110&pathTaken=partSearch&blt=14&prst=0&shdPart=4392067

Read More
JessicaM -
Sears Technician
February 01, 2013
A:

Are you sure this is correct for my model? I put in my model to see if it matched (DSXH43EF0WW) and it did not confirm. Thank you for your response. Scott

Read More
Scott -
February 02, 2013
A:

Yes, I am sure this is the correct kit for your model.

Read More
JessicaM -
Sears Technician
February 06, 2013
See more answers
Q:

My GE dryer model DSXH43EF0WW will not dry completely in any mode. The vent and filter are clean. It will buzz within a few minutes of start but it does not dry

A:

The main purpose of the GE dryer is to make our lives easier and when it does not dry the clothes properly it can be frustrating. I am providing a few links that may help while waiting for an expert answer.

Read More
Anna T -
May 28, 2012
A:

I can understand how frustrating it is to have issues with your dryer, especially when you need to use it. When the dryer is not drying completely this is usually due to a restricted air flow, which means a blocked vent. If the venting is good I suspect the heating element or a thermostat problem. If there is a doubt about the temperatures then remove the vent and run the dryer in high heat and check the temperature in the exhaust air. It should cycle between 135 to 160 degrees. If the air reaches theses temperatures then it's heating okay.

Sometimes an element can be broken and the wires will lie across each other so when voltage is applied the element heats. At some point the element heating causes the wires to expand and separate and it will stop hearing till it cools off again. The element can be visually inspected for this problem. I would recommend that you have a technician do the other test for you. If you would like to schedule service, just click on this link: Sears Home Services . If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
May 30, 2012
See more answers

Top Parts