Model #DSXH43EA1WW GE Residential Dryer

  • Controls & Top Panel
    3 Results
  • Front Panel & Door
    3 Results
  • Cabinet & Drum
    3 Results
  • Motor
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

stacking washer and dryer

A:

That's great to hear that you are wanting to double check if you are going to stack the units correctly. I placed the link to sears.com they would be able to help you upon your question.

Read More
celene -
January 31, 2011
A:

I was on a live chat with them and they sent me here to find out if it would be okay....

Read More
Marcia -
January 31, 2011
A:

You should be able to stack that dryer on the top of the washer using the stacking kit listed for the dryer (part WE25X10004). Both the washer and the dryer are manufactured by Frigidaire (for GE and Kenmore).

You can order the stacking kit from the Sears PartsDirect website. Here is a direct link for that part: Kit-stacking-washer/dryer .

I provided stacking instructions in the images below.

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
February 02, 2011
See more answers
Q:

how do I take a GE electric dryer/ model munber DSXH43EA1WW appart?

A:

To help you on taking your dryer I was able to locate some information that can help you. I have attached the link below. I hope its helpful!

Read More
Maira -
January 05, 2011
A:

On this model you want to remove the belt first. First, disconnect power to the dryer. Slide the dryer out carefully to avoid floor damage. You will see the small access panel on the lower left. Remove the access panel using caution to avoid sharp metal edges. Reach in to release tension off the idler pulley & slip the belt off both the motor & idler pulleys. You can now move around to the front. Push the dryer back slightly & use a putty knife in between the top & front to release the spring clips holding the top down. Lift the top up & lean it against the wall. Now you can reach in to remove the 2 screws holding the front panel to the side panels. After removing those 2 screws the front panel will pull forward & lift slightly to remove. Make a note on where the 2 wires are connected to the door switch & disconnect them. Now you can set the front panel to the side. Next you want to lift the rear section of the drum up far enough to release the rear bearing ball hitch. Use caution here for sharp edges. Lift the drum completely out of the dryer using the belt as a handle. You should now have complete access to all of the internal components. I am sending you some images to help guide you along. Please click on the images below for more information on accessing the dryer. NOTE: follow my written instructions to lift the top panel, the dryer in the image is slightly different but everything else should be the same.

The first responder's link is not for this model.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: sears home service

Read More
biker dave -
Sears Technician
January 07, 2011
See more answers