Model #DLG5932W LG Residential Dryer

  • Control Panel/plate Assy
    3 Results
  • Cabinet/door Assy
    3 Results
  • Drum/motor Assy
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Do I need the adapter kit for the pedestal installation of my LG washer and dryer?

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I would suggest that you provide a little more information such as the make and complete model number of your product so your expert will be able to provide you the best possible answer. Just click on reply below where you can provide the additional information. Have a great day!

Read More
Alina F. -
June 07, 2012
A:

Here is the model # & serial # of my washer & dryer: Washer Model #: WM2487HWM Washer Serial #: 706KWXD01002 Dryer Model #: DLE7177WM Dryer Serial #: 705KWTA06649 The adapter is sold by Sears Parts Direct and is not returnable. The part # is: AAA30793428. The Sears salesperson where I purchased the LG WDP4W pedestals is telling me I don't need these adpaters, but I don't want to find out in the middle of installing them that this salesperson was wrong. Thanks in advance!

Read More
Patty -
June 07, 2012
A:

Thank you for submitting your question. The pedestal that goes to your washer and dryer is model number WDP3W on the LG web site and item number 02651022000 on our Sears.com web site. It's the same item. Here is the pedestal installation manual . It appears that the pedestals will come with their own hardware and the adaptor is not needed after reading through the installation guide. I hope this information helps. Thank you for choosing Manage My Life.

Read More
Tykara -
Sears Technician
June 09, 2012
A:

I don't understand. The product that you mentioned above (02651022000) is a Kenmore correct? There is apparently an issue based on the age of my washer 2007 and earlier, which require the WDP3W. However, the salesman at the outlet store that is selling the WDP4W for a great price is telling me that I can use this newer model pedestal without an adapter whereas LG is telling me that I do need the adapter. Who is right?

Read More
Patty -
June 13, 2012
A:

What I need to know is whether I need an adapter to attach the WDP4W pedestal to my washer (Washer Model #: WM2487HWM Washer Serial #: 706KWXD01002). Please help me verify this so that when I get ready to install the WDP4W pedestals, I have the right adapter on hand. Thanks!

Read More
Patty -
June 13, 2012
A:

When looking at your product information for your washer the WDP3W and WDP4W is what was listed for the pedestal. I just gave you the first one because both will work. The instructions for the WDP3W states all the hard will come with the pedestal for installation and the adapter kit is not listed as being needed. This however is LG's product, so I would go off the information LG is providing you because they are the manufacture.

Read More
Tykara -
Sears Technician
June 13, 2012
A:

Hello Fellow LG Buyers. I understand your aggravation and frustration. I have an LG DLG5932W (DRYER) AND A WM2032HW (WASHER) that I purchased in 2004. I finally decided to purchase the pedestals for them and was very excited when I got them. Then when my husband and I tried to connect the W/D to the pedestals, we realized the white connectors cannot be used to hold our W/D in place because the W/D doesn't have the holes underneath where the white connectors are supposed to slide into. After painstakingly searching the web, I finally found the answer for us. I am adding a picture of the Adaptor Kit you will need in order to hold your W/D in place to the WDP4 pedestals. I've seen the price on line for about $5.99. I am also providing a link to an LG Manual I found that will show you how the ADAPTOR KIT AAA30793428 should be attached to your W/D and pedestals. I hope the link works and I HOPE THIS IS HELPFUL !

Read More
Cheryll -
June 23, 2012
A:

on pg. 4 of theLG PEDESTAL KIT Installation Instructions Booklet, there are four holders that aperantly have two parts to it, the T Clip that attaches to the bottom of the washer or dryer and the retainer that screws to the pedestal with #2 screws .

Read More
robert -
October 12, 2012
See more answers
Q:

how to change igniter on lg gas dryer

A:

A dryer that is not heating can be very inconvenient since you need to dry your clean wet clothes so I hope to be of some help. While you are waiting for an expert answer, I did manage to find a link that will provide you with more information about your problem. I hope my link is useful.

Read More
Joseph P. -
November 17, 2010
A:

Thank you for your question.

I should be able to help you replace the ignitor in the dryer. If you are not sure if the ignitor is bad, you can ohm it with a volt ohm meter. First, unplug the dryer and follow the instructions below on how to open the dryer for service. Once you have located the ignitor, you can unplug the wires and ohm it out. If it shows an open reading, it is defective. If you get a reading of ohm, the ignitor is fine. The problem could be and open thermo fuse. Remove the wire on the thermo fuse and ohm it out if it shows open it is defective.

If you need further assistance and feel comfortable making voltage checks please reply below.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 18, 2010
See more answers
Q:

Why does my LG gas dryer keep popping the manual reset limit switch?

A:

From what you described it sounds like the exhaust vent is blocked or restricted. On a gas dryer if the venting is restricted you will have a lazy flame. The heat from the lazy flame trips the thermostat. I recommend cleaning the exhaust venting & replacing the thermostat if it keeps popping.

Read More
biker dave -
Sears Technician
November 14, 2009

Top Parts