Model #DE7500 MAYTAG Residential Dryer

  • Control Panel
    3 Results
  • Front View
    3 Results
  • Rear View
    3 Results
  • Front Panel & Door Assembly
    3 Results
  • Lint Screen, Tumbler (front & Back)
    3 Results
  • Inlet Duct & Heater Assembly
    3 Results
  • Motor, Blower, Base Frame & Thermostats
    3 Results
  • Thermostats
    3 Results
  • Installation Accessories
    3 Results
  • Inlet Duct & Heater Assembly (series A3)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

dryer won't turn on/run

A:

There are two fuses on these dryers. I have provided a link below that has a image you can review. You will also receive an expert response from our team within a day or two. I hope this helps you get your dryer back on it's feet. Have a nice evening.

Read More
Henry -
September 10, 2012
A:

My suspicion is the thermal fuse on the blower housing is the problem. The wiring diagram below may be helpful to you. There is also a fuse on the heater housing that should be check for continuity if a meter is available. I hope this helps. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
September 11, 2012
See more answers
Q:

Clothes stopped spinning in dryer. belt?

A:

I can understand how frustrating it can be not having a working dryer. Researching around I was able to find some information that can be very helpful. I have attached the links below hope they help!

Read More
Maira -
December 22, 2010
A:

From what you're describing I suspect something stalled out the drum. Look inside the dryer for something stuck between the baffle & bulkhead. If the drum is unable to turn you will get a burning smell from the belt. I recommend removing the front panel so you can get a better view of all the internal parts. Remove the 2 lower screws & pull the lower section of the panel out to unhinge the top clips. (see image below)

Testing the thermostats will require using a meter. Let us know if you have a meter & decide to perform the tests.

Remember to disconnect power before attempting access.

After making these initial checks please get back with us if you need further assistance.

Read More
biker dave -
Sears Technician
December 23, 2010
See more answers
Q:

How can you get to the heating element and thermostat on a Maytag dryer?

A:

The front panel will need to be taken off in order to access the heating element. There are two (2) screws located near the bottom of the front panel to remove. Tilt the bottom of the front panel outwards and then pull it down to remove. See images below. NOTE: Disconnect the power cord from the power source before removing the front panel.

Read More
Joey S -
Sears Technician
October 20, 2009

Top Parts