Model #DE312 MAYTAG Residential Dryer

  • Control Panel
    3 Results
  • Front View
    3 Results
  • Rear View
    3 Results
  • Door
    3 Results
  • Tumbler-gray
    3 Results
  • Tumbler-beige
    3 Results
  • Heater
    3 Results
  • Motor Drive
    3 Results
  • Motor Drive-thermostats
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Not heating and no air blow DE312 Maytag Maytag laundry

A:

Thank you for choosing SearsPartsDirect.com. I will be more then happy to assist you. Looking at this maytag I'm showing that there are many fuses or Thermostats That could be the main issue. I suggest replaces all of them at one time. Replacing all those will intern fix your heat issue plus the not blowing air at all. . Hope this information has help you, any further questions or concerns. You will have to post a new question because at this time I can not reply to any comments. Again, Thank you for choosing SearsPartsDirect.com.

Read More
Samantha A -
Sears Technician
June 02, 2014
Q:

Maytag Dryer

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Carmen G -
January 02, 2013
A:

Hi,

Thank you for asking this question and allow me to answer it this way.

The de312 is powered by 240 volts AC and requires the larger pig tail power cord to function.

I hope this answer is useful and that it helps you correct the problem with your appliance.
Thank you for using ManageMyLife.

Read More
Bill__W -
Sears Technician
January 03, 2013
See more answers
Q:

My dryer is making a bumping noise.

A:

Noisy dryers can certainly get your attention. I found a similar question from a previous thread that may help while you wait for the expert to answer for your model. I attached the link below. Hope this helps!

Read More
Barbara H. -
January 08, 2011
A:

The bumping noise is most likely the drum roller.

The 12001541 drum roller supports the back of the drum. If it gets a flat spot then when the drum passes it makes a thump. The roller can be obtained from the following link: Sears PartsDirect .

You can access the rollers by removing the front panel. There are two screws located at the bottom corners of the front panel. Remove the screws and pull out on the bottom of the panel. When the panel is about 90 degrees up the top will release. Next you will need to remove the front bulkhead and drum to access the drum rollers.

I hope this helps. You can reply with any additional details or questions for further assistance.

Read More
Fred M -
Sears Technician
January 10, 2011
See more answers

Top Parts