Model #D2100 MAGNAVOX Portable Audio

  • No Image Available - Fidelitone
    3 Results
Find part by diagram >

Question and Answers

Q:

kenmore gas range moded # 790.7575D2100

A:

I am sorry to hear that you are experiencing some difficulties with your Kenmore gas range. Managemylife.com can take the mystery out of the repair. Your expert can help you determine if you should consider replacing or repairing an appliance. I did some research for you at this web page and found an expert answer to a similar question which may shed some light on the problem. If you decide to schedule service, and have a qualified technician to assist you, I have attached the link to searshomeservices.com. I hope these links below will be useful until your expert can respond.

Read More
James -
January 04, 2013
A:

Thank you for your question and I understand your concern.

There is nothing in the electrical system to cause a humming noise when either the oven or surface burners are on unless the hum is coming from the clock/oven control. If that is the case, it may need a new oven control. You could also be hearing the gas pressure regulating making noise as it's regulating the gas pressure/flow if the noise appears to be coming from bottom back left corner where the gas supply is connected.

The oven is likely taking too long to ignite because the glow bar igniter is too weak. I recommend replacing the bake igniter and your oven will likely ignite normally again.

The bake igniter #5303935066 for model 790.7572100 can be ordered from Sears Parts Direct.

To access and replace the bake igniter the oven bottom will need to be removed. There will also be flame spreader that will need to be taken off to. Remove the nut in the center of the flame spreader and lift it off. NOTE: Disconnect the power cord from the power source before servicing.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 05, 2013
See more answers