Model #CVS36RS THERMADOR Range Hood

  • 3 Results
  • Wiring Diagram
    3 Results
  • Fasteners
    3 Results
Find part by diagram >

Question and Answers

Q:

Thermador "Cook 'N' Vent" vent issue

A:

I am understanding the issue that you are having with the vent. I have found a link that might help you further. The link has some issues and questions that were asked, the answers that were given are great. I hope that the information might help you fix your issue.

Read More
celene -
March 25, 2011
A:

Thank you for your question and I understand your concern.

There is likely a mechanical failure or an switch failure preventing the vent snorkel from stopping when it reaches the full up position. The is a small micro switch (key#46)that should cause the snorkel to stop once it reaches the full up position and strikes the limit switch. This switch is usually located near the drive motor. In order to access and locate the switch will require crawling under the counter and removing the panels covering the motor and the mechanical actuators.

I do not have any specific instructions or images to add to assist you in doing it yourself. I did add an image below showing the micro switch. I strongly suggest calling a service technician to diagnose and repair your Thermodor vent system. If you do plan on doing it yourself, disconnect the power supply from the power source before removing any access panels.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 28, 2011
See more answers
Q:

Thermador "Cook 'N' Vent" vent issue

A:

duplicate

Read More
celene -
March 25, 2011
A:

Thank you for your question and I understand your concern.

There is likely a mechanical failure or an switch failure preventing the vent snorkel from stopping when it reaches the full up position. The is a small micro switch (key#46) that should cause the snorkel to stop once it reaches the full up position and strikes the limit switch. This switch is usually located near the drive motor. In order to access and locate the switch will require crawling under the counter and removing the panels covering the motor and the mechanical actuators.

I do not have any specific instructions or images to add to assist you in doing it yourself. I did add an image below showing the micro switch. I strongly suggest calling a service technician to diagnose and repair your Thermodor vent system. If you do plan on doing it yourself, disconnect the power supply from the power source before removing any access panels.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
March 28, 2011
See more answers